Your Selected Vehicle
Parts for your 1995 Suzuki Swift-Headlight bulbs
Explore 4WD & Adventure
Narva Surefit H4 LED GEN II Headlight Bulb Twin Pack - 18434
Narva H4 Headlight Bulb 12/24V LED GEN III Conversion Kit Twin Pack - 18444
Narva 9-33 Volt LED Rear Stop/Tail, Right Hand Squential direcion indicator and reverse lamps with in built retro reflector and 0.5m hard wired cable - 97312R
Narva Model 72 Rear Stop/Tail/Indicator Lamp With In-Built Retro Reflector, With 0.5M Of Cable
Narva Model 72 Rear Stop/Tail/Indicator/Reverse Lamp With In-Built Retro Reflector, With 0.5M Of Cable
1995 Suzuki Swift headlight bulbs
Headlight bulbs are absolutely relevant to the 1995 Suzuki Swift. Technical references including the Suzuki Swift SF-series workshop manual, the 1995 owner’s handbook, and major bulb application catalogues from Philips/Osram specify a replaceable halogen H4 (12V 60/55W) dual‑filament bulb for each headlamp. That means the Swift uses a standard, serviceable bulb rather than a sealed-beam or factory LED unit.
On a ’95 Swift, the headlight bulb’s job is simple but crucial: throw a clean, legal beam pattern for low and high beam so night driving stays safe and compliance-friendly. The H4 bulb houses two filaments, handling both dipped and main beam in the same globe. Over time, halogen bulbs fade, the light colour shifts more yellow, and output drops, even before a filament finally pops. That’s why proactive replacement is smart, especially if the car does a lot of night kilometres.
Best practice is to replace headlight bulbs in pairs to keep the colour and brightness even from side to side. Use quality, ADR/UN ECE‑approved H4 60/55W bulbs to stay legal in Australia and New Zealand. LED “retrofit” bulbs in a halogen housing are generally not road-legal unless the entire lamp is certified for them, otherwise they can fail a WoF/RWC check and cause glare.
DIY replacement on the Swift is straightforward under the bonnet: unplug the 3‑pin connector, peel back the rubber boot, release the spring clip, swap the globe, and refit everything in reverse. Don’t touch the glass—skin oils create hot spots that shorten bulb life. After fitting, check beam aim on a flat surface, if a lens looks cloudy or there’s moisture inside, sort the seal or lens condition so the new bulbs can perform properly.
During regular servicing, a quick lighting check pays off. Look for dimness, flicker, or a pinkish tinge (a sign a filament is near the end). Inspect the connectors for heat discolouration, ensure the earths are clean, and keep the headlamp lenses clear of road grime. Many owners opt for “long‑life” H4s for durability, or “plus output” halogens for a brighter but still legal upgrade—just stick to the correct wattage.
- Bulb type: H4, 12V 60/55W halogen (dual filament)
- Replace in pairs, avoid touching glass
- Confirm legality before considering LED conversions
What headlight bulb does a 1995 Suzuki Swift use?
Most 1995 Swifts take an H4 12V 60/55W halogen bulb with a P43t base. Variants and market differences are rare, but it’s worth checking the owner’s handbook, the marking on the headlamp cover, or a trusted parts catalogue by VIN to be sure.
Can LED bulbs be fitted to a 1995 Swift for road use in AU/NZ?
Generally no, unless the entire headlamp assembly and the LED light source are certified to the relevant ADR/UN ECE standards. Retrofit LEDs in halogen reflectors often cause glare and can fail WoF/RWC. Keep LEDs for off‑road unless you have certified components.
Why replace headlight bulbs in pairs?
Halogens dim with age. If only one side is new, the beam pattern and colour won’t match, which can affect visibility and annoy oncoming traffic. Pair replacement gives balanced light and reduces the chance of the other side failing soon after.