Parts for your 1995 Mitsubishi Pajero-Wiper refills

1995 Mitsubishi Pajero wiper refills — what they do and when to replace them

Yes, wiper refills are relevant and used on the 1995 Mitsubishi Pajero. Technical documentation for the NH/NJ/NK-series Pajero specifies replaceable rubber inserts for the windscreen wiper blades, rather than mandating full blade replacement. This is supported by the Mitsubishi Pajero Workshop Manual (Wiper and Washer section), the Mitsubishi ASA electronic parts catalogue (listing wiper blade rubber/inserts for front and rear), and Australian application guides from major brands that offer insert-style refills for this model’s conventional frame blades.

On a ’95 Pajero, wiper refills are simply the rubber inserts that slide into the existing metal wiper blade frames. Their job is straightforward: maintain a clean, streak‑free view of the road by keeping the windscreen clear in rain, spray, dust, and mud. Because the Pajero often sees outback conditions, coastal salt, and UV exposure, the inserts cop a fair hiding and harden or nick over time.

As part of regular servicing, it’s smart to inspect and replace refills before they become a visibility headache. Tell‑tales it’s time include streaking, squeaking, chatter, missed patches, or frayed edges. A quick thumb-and-fingernail pass along the edge will reveal nicks or glazing. Most owners in Australia and New Zealand will see the best results replacing every 6–12 months, more often if the vehicle lives outdoors or tackles dusty tracks.

Replacement is straightforward if the existing blade frames are in good nick:

• Lift the wiper arm gently and support it to avoid snapping back on the glass.
• Slide out the old insert, noting the metal rails and the locking end.
• Match the new refill to the old one for length and insert width (common widths vary, ensure the insert suits the frame’s groove).
• Transfer or retain the stainless guide rails if required, then feed the new rubber in until it locks.
• Wipe the windscreen and run the washers to bed the edge in.

Handy care tips: clean the windscreen and blade edges regularly with washer fluid, avoid petroleum cleaners on the rubber, and park the blades off a hot, dry windscreen when possible to reduce set. If the metal blade frames are bent, rusty, or the joints are sloppy, swap to new complete blades, refills won’t fix a worn frame. Always replace both front inserts together and don’t forget the rear wiper if fitted.

Technical sources: Mitsubishi Pajero (NH/NJ/NK) Workshop Manual – Wiper & Washer System, Mitsubishi ASA Electronic Parts Catalogue (Pajero 1991–1999, wiper components), Australian/NZ wiper application catalogues from major manufacturers specifying insert refills for 1995 Pajero.

Popular questions about 1995 Mitsubishi Pajero wiper refills

What size refills does a 1995 Pajero take?
Sizes can vary with the blade frames fitted. The simplest approach is to measure the existing inserts for length and confirm the groove/insert width on the frame (commonly 6 mm or similar). Many owners choose complete blades by length, but if sticking with inserts, match length and width to the current frames or check a local parts guide for the specific trim and market.

Can full blades be used instead of refills on this model?
Absolutely. The Pajero of this era uses a standard hook‑style wiper arm, so complete replacement blades fit easily with common adaptors. It’s a good option if the original metal frames are worn or corroded. If the frames are sound, inserts are a cost‑effective, perfectly acceptable choice.

How often should the refills be replaced in AU/NZ conditions?
Plan on 6–12 months, sooner if the vehicle sees lots of UV, coastal air, red dust, or off‑road work. If you notice streaking, judder, or squeal, don’t wait for the next service—fresh refills restore clear vision and reduce driver fatigue straight away.