Your Selected Vehicle
Parts for your 1993 Nissan Primera-Headlights
LED Autolamps 12/24V LED Stop/Tail/Indicator/Licence LED Light With 4 Pin Plug - 99ARLM4P
LED Autolamps 12V Indicator Strip Lamp With 10 Square LEDs Recessed Mount - 235A12
LED Autolamps 12V LED Boat Trailer Lamps Stop/Tail/Indicator with Licence Plate Lamp Light Left & Right Side, with 8m cable, Twin Blister - 209GARLP2/8M
Explore 4WD & Adventure
LED Autolamps 12/24V Stop/Tail/Indicator Light Clear Lens Coloured LEDs Surface Mount - 12ARM-2
LED Autolamps 12/24V Maxilamp Stop/Tail/Indicator/Reverse/Reflector Combo Lamp Black Chrome - MAXILAMPC3XRWB
LED Autolamps 10/30V Side Direction Indicator In Blister Pack With 3 LEDs - 58AM
LED Autolamps 12V 2x Stop/Tail/Indicator Boat Trailer Lamps with Licence Plate Lamp, includes Left & Right Side - 207BARLP2
LED Autolamps 12V LED Stop/Tail/Indicator Lamp With Licence Plate Lamp Blister Pack Containing Left & Right Lamps - 99ARL2
LED Autolamps 12/24V 280 Mini Jumbo Stop/Tail/Indicator/Reverse LED Light Blister Pack - 280ARWM
LED Autolamps 12V LED Stop/Tail/Indicator Lamp With Reflector 150x80x22M - 151BAR
LED Autolamps Twin function front position with supplementary front indicator - 97WIMCSB
LED Autolamps 10/30V Front Outline Position Marker With 2 White LED Blister Pack - 58WM
LED Autolamps Twin function rear position with supplementary rear indicator - 97CRIMCSB
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIMCSB
LEDAUT 12V Stop/Tail/Indicator/Reverse Light 275x100mm Blister Pack - 275ARW
LED Autolamps 12/24V LED Rear Combination Stop/Tail/Indicator/Reverse Light with Reflectors, Blister Pack - 250ARWM
LED Autolamps 12V Stop/Tail/Indicator 380 Series Strip Lamps In Double Black Bracket - 380BAR12
LED Autolamps Twin Function Side Indicator with Red Amber Side Marker RHS Multivolt - 800ARIMR
LED Autolamps Multi Volt Rear Indicator Lamp With 8 Square LEDs Blister Pack With Black Base - 135AM
1993 Nissan Primera headlights
Headlights are absolutely fitted to and relevant for the 1993 Nissan Primera (P10). This is documented in the Nissan Primera P10 factory service manual and owner’s manual lighting sections, and required by Australian Design Rules (ADR 13/00 and ADR 46/00) as well as New Zealand’s Land Transport Rule: Vehicle Lighting 2004. Those technical sources mandate compliant headlamps for safe road use, so this model ships with halogen headlights from factory.
On a ’93 Primera, the headlights do the heavy lifting for night driving and poor weather, projecting a legal beam pattern suited to right-hand-drive markets like Australia and New Zealand. The units are halogen reflector lamps, typically using an H4 60/55W dual‑filament bulb for low and high beam in one globe. Keeping them in good nick means better visibility, less fatigue, and a happier WOF or rego inspection.
When it’s time to replace a bulb, it’s a straightforward job under the bonnet. Access the rear of the headlamp, pop off the dust cap, unclip the spring retainer, and swap the H4 globe. Don’t touch the glass with bare fingers—oils shorten bulb life. Refit carefully, ensuring the rubber boot seals out moisture. It’s smart to replace bulbs in pairs so colour and brightness match. Stick with the factory wattage, higher-watt globes can overheat wiring and may not be ADR-compliant.
Routine care goes a long way. If the lenses have gone cloudy or yellow, a quality plastic headlight restoration kit can restore clarity—finish with a UV sealant to keep the haze away. Check connectors and earths for corrosion, a dodgy ground or voltage drop will make lights dim. If light output still feels weak after fresh bulbs and clean lenses, have the charging system tested and the headlight aim checked using proper equipment.
- Use ADR/UNECE-compliant H4 halogen bulbs for AU/NZ.
- Keep lenses clean, restore and seal if they’re hazed.
- Inspect fuses, connectors, and earth points during servicing.
- Have a workshop or WOF station verify beam aim and pattern.
What bulb type fits a 1993 Nissan Primera headlight?
Most P10 Primeras use an H4 60/55W halogen for combined low/high beam. Parking/position bulbs are usually W5W (T10). Always confirm against the owner’s manual or the existing bulb, as trims and markets can vary. Avoid non-approved HID/LED retrofits that can breach ADR/WOF requirements.
How does one adjust the headlight aim?
Use the vertical and horizontal adjusters on the back of each lamp. Park on level ground facing a wall, mark the cut-off, and make small changes. For best results—and to stay compliant—have a workshop or WOF inspector set the aim with a beam setter to the specifications in the service manual.
Why are the headlights dim or yellow?
Ageing halogen bulbs, UV-hazed plastic lenses, corroded earths, or voltage drop in old connectors are common culprits. Fit fresh quality H4 bulbs, restore the lenses with a sealant, and clean or repair wiring and grounds. If brightness is still off, get the alternator/charging voltage and beam aim checked.