Skip to content Skip to navigation menu

Your Selected Vehicle

Parts for your 1991 Nissan Primera-Wiper refills

Sort by
Showing 1 - 4 of 4 products

1991 Nissan Primera Wiper Refills

Yes — wiper refills are relevant for the 1991 Nissan Primera (P10). Technical sources including the Nissan Primera P10 factory service manual (Wiper & Washer section), Nissan FAST electronic parts catalogue entries for P10 blades, and common aftermarket fitment guides from brands like Trico and Bosch all specify insert-style rubber refills for the original metal-framed front wiper blades. On hatch and wagon variants, the rear wiper also accepts a shorter refill. That means owners can replace just the rubber insert rather than the entire blade assembly, keeping the car tidy and costs down.

Purpose-wise, a fresh refill restores clear vision by maintaining a consistent, even wipe across the windscreen. Over time, UV, road grime and ozone harden the rubber, leading to streaking, chatter and poor wet-weather performance. In Australian and New Zealand conditions — with strong sun and salt-laden air in many regions — refills are a sensible, budget-friendly maintenance item.

For servicing a 1991 Primera, the shop approach is pretty straightforward: inspect the wipers every service, replace the inserts every 6–12 months, and sooner if there’s smearing, judder, or splits in the edge. If the blade frames are floppy, rusty or warped, it’s smarter to replace the whole blade and then use refills next time.

  • Measure the old insert length and check the insert profile (commonly 6 mm or 8 mm). Keep the thin stainless rails from the old insert if they’re separate — many refills reuse them.
  • Release the end clip on the blade, slide the old rubber out, and gently feed the new refill in. A dab of soapy water helps it glide.
  • Seat the locking tab, run the washers, and check the sweep. If there’s streaking, re-seat or trim the refill to exact length.

Most P10s use conventional hook-style wiper arms, but it’s wise to confirm the arm type and insert width before purchase, especially on JDM imports. Hatch and wagon owners should note the rear uses a shorter refill. Keeping the windscreen clean, topping up proper washer additive, and occasionally wiping the blades with a damp cloth will make each refill last longer. In frosty areas, lift the blades off the glass when parked to prevent the edge from sticking and tearing.

Popular questions about 1991 Nissan Primera wiper refills

What size wiper refills does a 1991 Nissan Primera use?
Sizes vary by body style and market. As a guide, the front driver’s side is often around 500–550 mm and the passenger side around 450–500 mm. Hatch and wagon rear refills are shorter (roughly 300–350 mm). Always measure the existing insert or check the owner’s handbook, and match the insert width/profile.

Can the factory wiper blades be refilled, or should the whole blade be replaced?
The original metal-framed blades on P10 models are designed for refills. If the frames are straight and snug, a new insert will do the job nicely. If the frames are loose, corroded or bent, replace the complete blade first, then use refills for future maintenance.

How often should wiper refills be changed in Australia or New Zealand?
Every 6–12 months is typical. Strong UV, coastal air and dusty conditions can shorten life, so look for early signs like streaks, chatter, missed patches or a frayed edge and replace as needed.

{ "@context": "https://schema.org", "@type": "FAQPage", "mainEntity": [ { "@type": "Question", "name": "What size wiper refills does a 1991 Nissan Primera use?", "acceptedAnswer": { "@type": "Answer", "text": "Sizes vary by body style and market. As a guide, the front driver’s side is often around 500–550 mm and the passenger side around 450–500 mm. Hatch and wagon rear refills are shorter (roughly 300–350 mm). Always measure the existing insert or check the owner’s handbook, and match the insert width/profile." } }, { "@type": "Question", "name": "Can the factory wiper blades be refilled, or should the whole blade be replaced?", "acceptedAnswer": { "@type": "Answer", "text": "The original metal-framed blades on P10 models are designed for refills. If the frames are straight and snug, a new insert will do the job nicely. If the frames are loose, corroded or bent, replace the complete blade first, then use refills for future maintenance." } }, { "@type": "Question", "name": "How often should wiper refills be changed in Australia or New Zealand?", "acceptedAnswer": { "@type": "Answer", "text": "Every 6–12 months is typical. Strong UV, coastal air and dusty conditions can shorten life, so look for early signs like streaks, chatter, missed patches or a frayed edge and replace as needed." } } ]}