Your Selected Vehicle
Parts for your 1990 Suzuki Jimny-Headlights
LED Autolamps 12/24 Multi Volt Stop/Tail Lamp 36 LEDs With 40cm Wire - 80RM
LED Autolamps 12V Round Stop/Tail Lamp With Red Lens Recessed Mount - 102R
LED Autolamps 12V Stop/Tail/Indicator Assembly 3 Lamps With 108 LEDs Black Bracket - 80BARR
LED Autolamps 12/24V Stop/Tail Lamp 49 LEDs With Bracket And 30cm Wire - 100RM
Explore 4WD & Adventure
LED Autolamps 12/24V Rear Indicator Lamp Red Reflector Blister Pack - 460AM
LED Autolamps 12V Stop/Tail/Indicator Lamp With Reflex Reflector 100x100x25mm - 100BAR
LED Autolamps Twin function side indicator with amber/red side marker - 97CARIM
LED Autolamps Amber LED Indicator Lamp Insert For J3 Series Blister Pack - J3AM
LED Autolamps Twin function side indicator with amber/red side marker - 97CARIMB
LED Autolamps Rear End Outline LED Marker Red 12/24v Red Lens 16cm Cable Blister Pack - 42RM
LED Autolamps Twin function front position with supplementary front indicator - 97CWIMB
LED Autolamps 12/2V Maxilamp LED Stop/Tail/Indicator/Reflector Black Chrome Bolt Mount - MAXILAMPC1XCE
LED Autolamps Multi Volt Rear Combination LED Lamp With Grey Housing And Base - 275GARWMB
LED Autolamps Red LED Stop/Tail Lamp Insert For J3 Series Blister Pack - J3RM
1990 Suzuki Jimny Headlights
Headlights are absolutely fitted to the 1990 Suzuki Jimny. Factory service manuals and period parts catalogues for the late-’80s to early-’90s Jimny/Sierra (SJ413/JA11) specify round halogen headlamps with H4 bulbs, complete with relays, fuses and aiming hardware. That aligns with Australian and New Zealand road standards of the era, which require operational low and high beams from the factory.
On a rugged little 4x4 like the 1990 Jimny, headlights do more than tick a legal box. They light up bush tracks after dark, help spot washouts in drizzle, and make the vehicle visible to others on misty mornings. The standard setup is a pair of 7-inch round housings taking 60/55W H4 bulbs in most markets, with some variants using sealed-beam units. Either way, clear lenses, sound wiring and correct aim make a big difference to night-time confidence.
As part of regular servicing, owners should give the headlights a quick once-over. Look for yellowing, crazing, or moisture inside the lens, check the connectors for heat damage, and confirm both beams fire cleanly without flicker. Dim output often points to tired bulbs, corroded earths, or voltage drop in the original wiring. A relay upgrade can sharpen brightness without jumping to over-wattage globes.
Replacing a bulb is straightforward on most 1990 Jimnys that use H4 capsules:
- Switch off and disconnect the battery negative.
- Remove the bezel and retaining ring, then ease the lamp forward.
- Unplug the 3-pin connector and spring clip, swap the bulb, and avoid touching the glass.
- Refit the clip, connector, lamp and ring, then test low/high beam.
If the vehicle has sealed beams, replace the entire lamp unit. After any work, check aim against a flat wall: low beam should dip slightly and the left cut-off should sit below oncoming eye height. Aim screws are on the bucket, a small screwdriver and patience go a long way.
Upgrades are tempting, but stick with quality ADR/E-marked lamps or bulbs. Over-wattage globes can cook factory switches unless relays and wiring are uprated. Keep the lenses clean, ensure good earths, and a 1990 Jimny will punch well above its weight after dark.
Popular questions
What bulb type does a 1990 Suzuki Jimny use?
Most 1990 Jimny/Sierra models take a standard H4 60/55W halogen. Some trims or markets used 7-inch sealed-beam units, which require swapping the full lamp rather than just the bulb. A quick look behind the bezel will confirm which version is fitted.
How do you adjust the headlight aim on a 1990 Jimny?
Use the adjuster screws on each headlight bucket. Park on level ground facing a wall about 3–5 metres away, set tyre pressures and vehicle load, then tweak vertical and horizontal screws so low beam dips slightly and doesn’t dazzle oncoming traffic.
Why are my Jimny’s headlights dim or flickering?
Common causes are ageing bulbs, corroded connectors or earths, and voltage drop through old wiring. Clean the contacts, check the fuses and relays, and consider a headlight relay harness to deliver full battery voltage to the lamps.