Parts for your 1990 Mitsubishi Pajero-Wiper refills

1990 Mitsubishi Pajero wiper refills — fitment, purpose and servicing tips

Technical sources confirm that refill-type wiper rubbers are used on the 1990 Mitsubishi Pajero. The Mitsubishi Pajero (late Gen I) Workshop/Service Manual – Body: Wiper & Washer outlines rubber insert replacement, Mitsubishi’s ASA electronic parts catalogue lists “rubber, windscreen wiper” refills for V1/V2/V3 series Pajero (circa 1988–1991), and AU/NZ fitment guides from brands such as Tridon include front wiper refills for this model. On that basis, wiper refills are relevant for the 1990 Mitsubishi Pajero.

On a 1990 Pajero, wiper refills are simply the rubber inserts that slide into the original metal blade frames. They’re there to keep the windscreen clear, sweeping off rain, road grime and coastal salt so the driver can see what’s ahead — on-road, off-road, and everywhere in between. Swapping the rubber instead of the whole blade is a budget-friendly, low-waste fix that keeps the factory frames working as intended.

For servicing, most owners will be better off replacing refills every 6–12 months, or sooner if the ute sees a lot of sun, dust, or beach air. UV exposure in Aussie and Kiwi conditions hardens rubber, and a tired insert will start chattering, streaking or missing patches of glass. It’s smart to change both fronts together for balanced clearing, and to give the glass a proper wash first so grit doesn’t chew through a fresh edge.

Replacement is straightforward: pop the blade off the hook arm, slide the old rubber out after releasing the end clip, clean the blade rails, then feed in the new refill (with the metal backing strips if supplied) until the locking tab clicks home. A touch of soapy water helps it glide in, and the blade should sit square with even pressure across its length. If the frame is bent, rusty or weak, step up to complete blades instead.

Some wagons also have a rear wiper, depending on the arm and blade style, it may accept a refill or require a model-specific blade. The best result comes from matching the refill width and profile to the blade frame and trimming to length if supplied long. Quality rubber with graphite or silicone coating will usually wipe quieter and last longer.

• Replace when there’s streaking, smearing, chatter, splits or a frayed wiping edge
• Measure refill width/profile against the old insert before purchase
• Always lower the bare arm gently onto a towel when blades are off to protect the windscreen

Popular questions about 1990 Mitsubishi Pajero wiper refills

What size wiper refills fit a 1990 Pajero?
Sizes vary by body style and the blade frames fitted over the years. The front uses two different lengths, many frames take a common narrow refill profile. The simplest method is to measure the existing blade lengths and match the refill width/profile to the old insert or a reputable AU/NZ parts guide.

Can the original blade frames be reused with new refills?
Yes, provided the frames are straight, the pivots aren’t seized, and spring tension is even. If the frame is warped, corroded or weak, a full blade replacement will wipe better than a new refill alone.

How often should refills be replaced on a 1990 Pajero?
Every 6–12 months is typical. Replace sooner if exposed to strong sun, off-road dust, or sea air, or at the first signs of streaking, chatter, or hardened rubber.