Parts for your 1987 Suzuki Swift-Exhaust mount

1987 Suzuki Swift Exhaust Mount

Technical sources including the factory workshop literature and period parts catalogues for the SA/AA-platform Suzuki Swift (mid-1980s through 1988) show rubber exhaust mounting insulators (“exhaust mounts” or “hangers”) fitted at the front pipe, centre section, and rear muffler. So yes, the 1987 Suzuki Swift uses exhaust mounts, and they’re an essential part of how the exhaust is supported and kept quiet.

On this model, the exhaust mounts suspend the pipework under the car and isolate vibration so the cabin stays calm and the system isn’t stressed at the manifold or flanges. They also keep the exhaust aligned, maintaining safe clearance from the body, beam axle and heat shields. When they age, the rubber perishes and sags, which can lead to knocks over bumps, rattles at idle or the tailpipe sitting cock-eyed.

As part of regular servicing, it’s smart to give the Swift’s exhaust mounts a quick once-over. Every oil change or 10,000–15,000 km, check the rubber insulators and the steel hangers welded to the exhaust.

• What to look for: cracks, splits, glazing, excessive softness, elongated holes, or a droopy tailpipe. Surface rust on brackets is common, heavy scale or cracked welds aren’t.
• Typical locations: one near the front pipe area, one around the centre resonator (if fitted), and one or two at the rear muffler.
• Replacement tips: support the exhaust with a jack stand, spritz the rubbers with silicone spray, and lever them off with a blunt tool. Refit with the same lubricant. Replace in pairs or across the system if they’re all the same age.
• Hardware: inspect bolts and clamps, use anti-seize on threads exposed to heat and road grime.

Owners can choose OEM-style rubber or upgraded polyurethane hangers. Rubber matches the factory feel and isolation, poly can last longer and hold alignment better, but may transmit a touch more vibration. After fitting, check tailpipe clearance to the bumper and beam, ensure no contact with the floor, and verify all joints are sealed. A minute spent here prevents rattles and protects the exhaust from undue strain—exactly what the Swift’s mounts are designed to do.

Popular questions about 1987 Suzuki Swift exhaust mounts

How many exhaust mounts does a 1987 Suzuki Swift typically have?
Most cars of this generation run three to four mounts: one at the front pipe area, one mid-section, and one to two at the rear muffler. The exact count can vary with trim and whether a centre resonator is fitted. A quick look under the car will confirm what’s there.

What are the signs the mounts need replacing on a 1987 Swift?
Tell-tales include a rattly exhaust at idle, dull thumps over bumps, visible sagging or skewed tailpipe, and occasional clunks on take-off. If the rubber shows cracks, is shiny and hardened, or the holes have stretched, it’s time to swap them.

Should I go OEM rubber or polyurethane hangers?
OEM-style rubber gives the quietest result and matches the factory feel. Polyurethane tends to last longer and helps hold alignment on rough roads, but may pass a little more vibration into the cabin. For a stock daily, rubber is ideal, for longevity or spirited use, consider poly.