Parts for your 1987 Mitsubishi Pajero-Wiper refills

1987 Mitsubishi Pajero wiper-refills

Based on technical references including the Mitsubishi Pajero 1983–1991 Factory Service Manual (Wiper and Washer section), Mitsubishi ASA parts catalogues listing “insert, wiper blade” for first‑gen Pajero chassis, and Australian/NZ application guides from Bosch and Trico that specify refillable blade inserts for this model, wiper-refills are relevant and used on the 1987 Mitsubishi Pajero. The vehicle was supplied with conventional metal-framed wiper blades designed to accept replaceable rubber inserts.

For the 1987 Pajero, wiper-refills do the simple but vital job of keeping the windscreen clear by maintaining a clean wiping edge without needing to replace the whole blade assembly. Being an old-school, tough 4x4, it’s set up perfectly for refills—owners can slide out the tired rubber and rails, fit fresh inserts, and keep the original blade frames doing their thing. It’s cost-effective, reduces waste, and makes roadside fixes a breeze when touring.

As part of regular servicing, it’s smart to inspect the refills every few months. Aussie and Kiwi sun, red dust, tree sap, and salty coastal air can harden or nick the rubber. If there’s streaking, chattering, or missed patches, or the edge looks shiny and cracked, it’s time for new inserts. Most first-gen Pajero blades accept narrow-profile refills common to Japanese frames of the era, some aftermarket frames may use a wider insert—so checking the holder width and profile before buying is the go. Length can vary by body style and market, and wagons often have a smaller rear wiper insert, so a quick measure of the existing blade helps avoid guesswork.

• Lift the arm, unclip or slide off the end cap on the blade if fitted, and pull the old insert out of the claws.
• Match the new refill by width/profile, keep the stainless backing rails with the new rubber if required.
• Slide the new insert fully home, refit the retainer/end clip, then trim to length if the kit allows.
• Clean the windscreen and the rubber with mild soapy water or isopropyl alcohol, then test with washers.

A couple of extra tips the Pajero appreciates: avoid dry-wiping dusty glass, keep the washer bottle topped with proper wash additive, and check wiper arm spring tension if the wipe is patchy. Upgrading to quality natural rubber or compatible silicone-profile refills can last longer in harsh climates—just ensure the profile and width suit the blade frame. These straightforward habits keep the ’87 Pajero’s visibility sharp, whether it’s commuting in the rain or crossing the High Country after a storm.

Question: What size wiper-refills fit a 1987 Mitsubishi Pajero?

Answer: Sizes vary with body style, market, and the specific blade frame on the vehicle. First‑gen Pajeros commonly use narrow (Japanese-style) inserts in the original metal frames, while some aftermarket blades may need a wider insert. The best approach is to measure the existing blade length and the insert width or check a current Australian/NZ wiper application guide for the exact combo, including the smaller rear wiper on wagons.

Question: How often should Pajero wiper-refills be replaced?

Answer: In Australian and New Zealand conditions, plan on every 6–12 months. Harsh UV, dust, and coastal air can shorten that interval. Replace sooner if there’s streaking, squeak, judder, or any nicks and cracks in the rubber, or after heavy off-road dust work and winter snow trips.

Question: Can silicone wiper-refills be used on the 1987 Pajero?

Answer: Yes—if the silicone insert matches the blade’s width and profile. Silicone can handle heat and UV well, but prep matters: thoroughly clean the windscreen and the insert to reduce initial squeak and ensure a smooth, quiet sweep. Always confirm compatibility with the existing blade frame before purchase.