Parts for your 2023 Toyota Camry-Tail lights

2023 Toyota Camry taillights: what they do and how to look after them

Taillights are absolutely fitted to the 2023 Toyota Camry and are legally required. Technical references including the Toyota Owner’s Manual for the Camry (vehicle lighting), Toyota’s Electronic Parts Catalogue (rear combination lamp assemblies for XV70-series Camry), Australia’s ADR 13/00 and ADR 49/00 lighting requirements, and New Zealand’s Land Transport Rule: Vehicle Lighting confirm the vehicle uses rear position lamps. The 2023 Camry runs LED rear combination lamps, so taillights are both relevant and integral to the vehicle’s safety and compliance in Australia and New Zealand.

On this Camry, the taillights are LED “rear combination” units that provide rear position (tail), stop (brake), indicator, and reverse functions. They’re designed for excellent visibility, quicker illumination, and long service life. The design typically splits across the rear quarter panel and boot lid, giving that crisp, modern look while keeping the car highly visible to drivers behind, day and night, in rain or bright sun.

As part of regular servicing, it’s wise to check the taillights every 10,000 km or six months. Keep lenses clean with a mild car wash solution, avoid harsh solvents, and don’t blast pressure washers directly at seals. If condensation appears, have the seals and vents inspected. Because most rear functions are LED, individual “bulb” swaps often aren’t possible, a failed LED usually means replacing the whole lamp assembly. Some variants may still use a conventional globe for reverse—if so, replace like-for-like with the correct wattage.

• Replace the assembly if the lens is cracked, chipped, or badly hazed
• Replace when LEDs are dim, flickering, or not lighting
• Address any water ingress or persistent condensation
• Fix damaged wiring, loose connectors, or broken mounts
• Update if a previous tint or film reduces brightness (may be illegal)

1. Open the boot and pull back the trim/liner to expose the lamp fasteners.
2. Disconnect the wiring connector and any globe holders (if fitted).
3. Remove mounting nuts/bolts and gently ease the lamp straight out.
4. Clean the mounting face, replace the gasket/seal if it’s flattened or torn.
5. Seat the new lamp, tighten fasteners evenly—don’t overtighten.
6. Reconnect, then test tail, brake, indicator, and reverse with a helper.

After fitting, ensure the light shows red to the rear and meets ADR/NZ lighting rules. Choose genuine or high-quality, ADR/NZTA-compliant parts. Avoid smoked films or non-compliant aftermarket lamps that can reduce brightness and attract a defect notice.

Popular questions about 2023 Toyota Camry taillights

Are the 2023 Toyota Camry taillights LED, and can the bulbs be changed?

Most 2023 Camry taillights use integrated LEDs for tail, brake, and indicators, which aren’t serviceable as separate bulbs. If an LED segment fails, the whole assembly is typically replaced.

Depending on the variant, the reverse light may still use a conventional globe. If so, that globe can be replaced individually—use the correct specification to maintain legal brightness.

How can they tell if the taillight needs a full replacement?

Look for cracks, water ingress, persistent condensation, or LED sections that are dim or dead. If the lens is damaged or the LED array has failed, a full assembly replacement is the proper fix to keep the Camry compliant and clearly visible.

Are smoked or tinted taillights legal in Australia and New Zealand?

Only if they still meet ADR 13/00/49/00 and NZ Vehicle Lighting Rule requirements for colour, intensity, and visibility. Many tinted options reduce output below legal limits, which can draw a defect notice.

If choosing aftermarket lamps, select ADR/NZTA-compliant units and avoid films that dull the light. The rear position and stop lamps must be clearly red and bright enough from the required angles.