Your Selected Vehicle
Parts for your 2020 Ford Fiesta-Headlight bulbs
LED Autolamps 174 Series Rear Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174AMB
LED Autolamps Multi Volt Round Indicator Lamp With Amber Lens Recessed Mount - 102AM
LED Autolamps Multi Volt Stop/Tail/Indicator Lamp Black Bracket With 40cm Wire - 80BSTIM
Explore 4WD & Adventure
LED Autolamps 24V Front Indicator And Park Light Chrome Bezel Blister Pack - 285CAW24
LED Autolamps 12/24V Front End Outline Marker Recessed Fitting Twin Blister - 7922WM2
LED Autolamps Twin function front position with supplementary front indicator - 97WIMCSB
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIMB
LED Autolamps Twin function front position with supplementary front indicator - 97WIMB
LED Autolamps 12/24V Side Marker Amber Lens Coloured LEDs Stainless Steel Bezel - 86AAM
LED Autolamps Rear End Outline LED Marker Red 12/24v Red Lens 16cm Cable Blister Pack - 42RM
LED Autolamps 12/24V Amber Marker Clear Lens Coloured LEDs Stainless Steel Bezel - 86AM
LED Autolamps Stop/Tail/Indicator Diffused Tail Function With Sequential Indicator - 520ARRMB
2020 Ford Fiesta headlight-bulbs — are they used on this model?
Based on Ford’s technical literature for Australia and New Zealand, conventional headlight-bulbs are not used for the 2020 Ford Fiesta that was officially sold in these markets (the Fiesta ST). The Ford Australia/NZ model specification lists LED headlamps with auto high-beam, and the corresponding Owner’s Manual notes the headlamp light source is a non-serviceable LED module that requires replacement of the complete lamp unit if it fails. Workshop information for the Mk8 Fiesta backs this up, detailing headlamp assembly replacement rather than bulb swaps for LED-equipped cars.
Why no headlight-bulbs? Ford integrated LED modules deliver a brighter, cleaner beam pattern, reduced power draw, and better durability than halogen bulbs. The LED projectors are sealed to protect against moisture and dust, and to maintain precise optical alignment that meets ADR/ECE lighting standards. Because the LED chip and heat sink are built into the assembly, there’s no separate low- or high-beam bulb to replace.
- Performance: Crisp cutoff and strong down-road illumination from the factory LED projector.
- Efficiency: Lower current draw helps overall electrical efficiency.
- Durability: Solid-state LEDs typically outlast halogen bulbs and handle vibration better.
Servicing tips for a 2020 Fiesta with LED headlamps are a bit different to a bulb-type setup. If a headlight looks dim, flickers, or drops out, start with simple checks: clean the outer lens with a pH-neutral wash, make sure there’s no heavy hazing or yellowing, and confirm the relevant fuses and connectors are sound. If the fault persists, a technician should scan for body control module faults and verify power and earth at the headlamp connector. Where an LED module has failed, the approved fix is to replace the headlamp assembly with a genuine, ADR-compliant unit and then check beam aim.
Note: In some overseas markets, certain 2020 Fiesta trims used halogen headlight-bulbs (commonly H7 low beam with a separate high beam). Those bulb types don’t apply to the 2020 AU/NZ lineup, which is why “headlight-bulbs” aren’t relevant for this vehicle locally.
Does the 2020 Ford Fiesta in Australia or New Zealand have replaceable headlight-bulbs?
No. The 2020 AU/NZ Fiesta (ST) uses integrated LED headlamps for low and high beam. There are no conventional headlight-bulbs to swap. If the light source fails, the complete headlamp assembly is replaced.
What should be checked before replacing a 2020 Fiesta LED headlamp assembly?
Clean the lens, confirm the correct fuses and relays, inspect the wiring and connectors for corrosion, and have a technician scan the body control module. If power and earth are good and there’s still no output, the LED unit is likely faulty and the full assembly should be replaced.
Can halogen or aftermarket LED bulbs be fitted to the 2020 Fiesta headlamps?
Not recommended. The AU/NZ 2020 Fiesta’s LED headlamp is a sealed, homologated unit. Swapping in bulbs or non-genuine assemblies can affect beam pattern and ADR compliance, and may cause glare or inspection issues. Use genuine, like-for-like headlamp assemblies.