Parts for your 2019 Toyota Hilux-Tail lights

2019 Toyota HiLux Tail-Lights

Tail-lights are absolutely fitted to the 2019 Toyota HiLux. Toyota’s 2019 HiLux Owner’s Manual specifies rear combination lamps that include tail (rear position) lighting, and Australian and New Zealand regulations require them: Australian Design Rules ADR 13/00 (installation) and ADR 49/00 (rear position lamps), plus the NZTA Land Transport Rule: Vehicle Lighting 2004, all mandate working tail lamps on road-going vehicles. So tail-lights are relevant to every 2019 HiLux, no matter the trim.

On this ute, tail-lights help other drivers see the HiLux from behind at night and in poor weather, marking the vehicle’s width and presence. They’re part of the rear combination lamp assembly and often share the housing with stop, indicator and reverse lights. Many 2019 HiLux grades use LED tail lamps for crisp brightness and long life, while others use replaceable globes, either way, keeping them bright and compliant is essential for safety, WOF/rego checks, and ADR/NZTA requirements.

Servicing the HiLux tail-lights is straightforward. A quick visual check during each service or every 10,000 km goes a long way. With the park lights on, confirm both rear lamps glow evenly and with the correct red colour. If one side looks dim or patchy, there may be a blown globe, a failing LED, a poor earth, or moisture inside the lens.

• Access and replacement:
  • Open the tailgate, remove the two lamp screws on the bedside, and pull the lamp rearwards to release the locating pins.
  • Bulb-type: twist the holder anticlockwise, swap the globe for the exact type and wattage listed in the owner’s manual, and avoid touching new globes with bare hands.
  • LED-type: the tail function is integrated, replace the complete lamp assembly with a genuine or ADR/NZTA-compliant unit.
• Testing: reconnect, switch on park lights, and confirm even brightness. Check brake and indicator while you’re there.
• Common culprits: water ingress (cracked lens or perished seal), trailer plug wiring back-feeding or blowing the TAIL fuse, or a loose connector after tray fit-outs.

To keep the lenses clear, wash with mild car shampoo—no harsh solvents or abrasive pads. Skip dark “smoked” covers that reduce light output, they can fail a WOF or breach ADR rules. If upgrading, choose ADR/NZTA-compliant lamps that match factory wiring to avoid hyperflashing or dash warnings. Keeping the HiLux’s tail-lights healthy means better visibility, fewer roadworthy hassles, and safer night drives.

Popular questions

Are the 2019 HiLux tail-lights LED or bulbs?
It depends on the grade. Higher trims like many SR5 models typically run LED rear combination lamps for the tail function, while WorkMate and some SR variants may use replaceable globes. A quick look at the lens (fine LED segments vs a single filament glow) or a check in the owner’s manual will confirm your setup.

How do you change a 2019 HiLux tail-light?
Open the tailgate, remove the two screws holding the rear lamp, then pull the assembly straight back. For bulb-type lamps, twist out the holder and replace the globe like-for-like. For LED tail lamps, the tail function is built in, so replace the entire lamp assembly. Test park, brake and indicators before refitting.

Will smoked or tinted tail-lights pass WOF/ADR rules?
Only if they remain ADR/NZTA compliant and maintain correct red colour and brightness. Many dark tints reduce output too much, risking a failed WOF or defect notice. Choose compliant assemblies and avoid overlays that dim the light.