Parts for your 2019 Mitsubishi Asx-Tail lights

2019 Mitsubishi ASX tail-lights: purpose, care and replacement

Tail-lights are fitted and absolutely relevant to the 2019 Mitsubishi ASX. Technical sources confirm this: the Mitsubishi Motors ASX Owner’s Manual (rear combination lamp section) specifies rear position (tail) lamps, Australian Design Rules ADR 13/00 and ADR 49/00 require rear position lamps on passenger vehicles, and New Zealand’s Land Transport Rule: Vehicle Lighting 2004 mandates operational tail lamps for road use. On that basis, tail-lights are standard equipment on the 2019 ASX.

On a 2019 ASX, the tail-lights sit within the rear combination lamp assembly and are there to make the vehicle clearly visible from behind at night, in rain and in low-light conditions. They mark the width of the vehicle so following drivers can judge distance and speed. Depending on market and trim, the ASX may use conventional incandescent globes or integrated LED elements for the tail-light function. Either way, they’re a legal safety device and a simple bit of kit that does a big job.

As part of regular servicing, it pays to check tail-lights along with brake, indicator and reverse lamps. A quick look once a month, or at each fuel stop, helps avoid a roadside defect or a failed WOF/RWC. Have someone stand behind the car while the park lamps are switched on, confirm both sides glow evenly and the lenses aren’t cracked or cloudy. Keep the lenses clean—grit and road film dull the light output.

If a globe type is fitted and one side looks dim or dead, replace the bulb with the exact specification shown in the ASX owner’s manual or on the lamp holder. Avoid touching the glass with bare fingers, and check the relevant fuse if both sides are out. For trims with LED tail-lights, the tail function is sealed into the lamp, if it fails, the rear lamp assembly is typically replaced as a unit. Using ADR/NZ-compliant parts ensures the correct brightness and colour.

• Inspect tail-lights at every service (10,000–15,000 km) or sooner if a warning or defect is noted.
• Replace cracked lenses promptly to prevent moisture ingress and corrosion.
• After any replacement, test with lights on, hazards flashing and brakes applied to confirm all functions.

Basic access on the ASX usually involves opening the tailgate, removing the trim cover, unplugging the connector and rotating the bulb holder. For LED variants, the lamp is unbolted from the body and swapped complete. A technician can confirm which style is fitted to the specific vehicle and handle resealing and alignment so it looks factory and stays watertight.

FAQs

Are the 2019 Mitsubishi ASX tail-lights LED or bulbs?
It varies by market and trim. Many 2019 ASX models use LED rear combination lamps, while others retain replaceable incandescent bulbs for some functions. A quick visual check (fine LED “points” of light) or a glance at the owner’s manual will confirm. If LED, the assembly is replaced as a unit when it fails, if bulb, just the globe is swapped.

Is condensation in the ASX tail-light a problem?
A light mist that clears after a drive is usually considered normal. Persistent fogging, visible droplets or water pooling suggests a compromised seal or a cracked lens. That can affect light output and may fail a WOF/RWC. Resealing or replacing the lamp assembly fixes the issue and protects the electrics.

Where is the tail-light fuse on the 2019 ASX?
The vehicle has fuse panels in the cabin and engine bay. The exact tail/park lamp fuse location and rating are listed in the owner’s manual fuse chart. Replace with the same amperage only. If the new fuse blows again, have the wiring and lamp units inspected to find the underlying fault.