Your Selected Vehicle
Parts for your 2019 Honda Odyssey-Headlight bulbs
Repco by Century Car Battery Superior Performance 500CCA - 55D23L MF
Repco by Century Car Battery 4x4 & SUV Ultimate Performance 760CCA - N70ZZLX MF
Repco by Century Car Battery Ultimate Performance 550CCA - 75D23L MF
Repco by Century Car Battery Ultimate Performance 710CCA - DIN65LHX MF
Explore 4WD & Adventure
Repco by Century Car Battery Superior Performance 400CCA - NS60L MF
Repco by Century Car Battery Ultimate Performance 600CCA - DIN53LHX MF
Repco by Century Car Battery Ultimate Performance 550CCA - 75D23R MF
Repco by Century 4x4 & SUV Battery Ultimate Performance 680CCA - NS70LX MF
Repco by Century Car Battery 4x4 & SUV Superior Performance 680CCA - N70ZZ MF
Repco by Century Car Battery Ultimate Performance 640CCA - DIN65LX MF
Repco by Century Car Battery Ultimate Performance 430CCA - NS60LX MF
Repco P21/5W Bayonet Off-set pins Globe 12V 21/5W BAY15d Pack of 2 - R380BLL
Repco by Century Car Battery Ultimate Performance 860CCA - DIN85LHX MF
2019 Honda Odyssey headlight bulbs
Based on Honda’s 2019 Odyssey owner’s manual and service information, plus common bulb catalogues used by workshops, this model year was built with two headlight setups depending on trim and market: halogen projector lamps that use replaceable bulbs, and factory LED headlamps that use a sealed LED module with no conventional “bulb”. So, headlight bulbs are relevant for Odyssey variants fitted with halogen lights, while LED-equipped variants don’t use traditional bulbs and require lamp/LED module service if a unit fails.
For Odysseys running halogen headlights, the headlight bulb’s job is simple and vital: throw clean, even light down the road so night drives, wet weather and rural runs stay safe and legal. Good bulbs help the Odyssey’s projector housings deliver a crisp cutoff, reduce glare to other road users, and keep WOF/rego inspectors happy.
As part of routine servicing, it’s smart to check headlight performance every service interval. Look for dimming, flicker, or a colour shift to a grey or yellow tone—classic signs a halogen bulb is on the way out. Many trims commonly use separate low and high beam bulbs, replace them in pairs so the light colour and brightness match.
- Confirm the exact bulb types for your trim and market in the owner’s manual or parts catalogue—fit only the specified wattage.
- Avoid touching the glass, skin oils can hot-spot and shorten bulb life. Use clean gloves or a tissue.
- Keep the rear dust caps seated and seals intact to prevent condensation and early failures.
- If a fuse has blown, check for water ingress or a chafed wire before simply refitting a new fuse.
Typical driveway replacement goes like this: switch the lights off, park safely, open the bonnet, access the rear of the headlamp, unplug the connector, twist the bulb anticlockwise to remove, then install the new bulb without touching the glass and twist to lock. Refit the cap, reconnect, and test both beams on a wall to confirm aim looks even. If the vehicle has factory LED headlights, there isn’t a serviceable “bulb”, any fault is diagnosed at the headlamp unit or LED driver level and repaired or replaced as an assembly per Honda service procedures.
Thinking about LED retrofits in a halogen housing? Choose ADR-compliant kits only, and have beam aim checked to avoid glare and WOF issues.
Popular questions
Which headlight bulbs does a 2019 Honda Odyssey use?
It depends on trim and market. Many halogen-equipped Odysseys use separate low and high beam bulbs, while higher-spec models may have factory LED headlamps with no replaceable bulb. The safest move is to check the owner’s manual or a trusted parts catalogue by VIN to confirm the correct bulb codes and wattage.
How often should headlight bulbs be replaced?
There’s no fixed kilometre interval for halogen bulbs, but output typically fades before failure. If night visibility has dropped or one side looks a different colour, replace both bulbs together for even light and to avoid an inconvenient failure.
Can halogen bulbs be upgraded to LEDs?
Yes, but only use ADR-compliant kits and ensure they’re suitable for projector housings. Poorly matched LEDs can scatter light and create glare. After any change, have the beam aim checked professionally.