Your Selected Vehicle
Parts for your 2019 Honda Cr-v-Headlight bulbs
LED Autolamps 174 Series Stop/Tail/Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174ARMB
LED Autolamps 174 Series Reverse Lamp 12/24V, Surface Mount, 40cm Cable - 174WMB
Explore 4WD & Adventure
LED Autolamps 174 Series Stop/Tail Lamp 12/24V, Surface Mount, 40cm Cable - 174RMB
LED Autolamps 12V Stop/Tail Lamp Black Chrome Round With Clear Lens - 102RBC
LED Autolamps 10/30V LED Side Direction Indicator Light With 30cm Wire - 35AMB
LED Autolamps 12/24V Round Stop/Tail Lamp With Clear Lens 130mm Diameter Recessed Mount Blister Pack - 102RCM
LED Autolamps Licence Plate Lamp Black Bracket Multi Volt With 1m Cable - 35BLM1P
LED Autolamps 12V Front Indicator Amber Lens Black Base Twin Blister Pack - 175A/2
LED Autolamps LHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284LHS
LED Autolamps 12/24V Reversing Lamp With 25 White LEDs With Bracket and 30cm Wire - 100WM
LED Autolamps 12V 82 Series Stop/Tail/Indicator/Reverse Lamp Black Bracket - 82BARW
LED Autolamps 12/24 Multi Volt Stop/Tail/Indicator/Reverse Assembly Lamp With 108 LEDs - 80BARWM
LED Autolamps 12/24V LED Reverse Lamp Screw Surface Mount Blister Pack - 12WM-2
LED Autolamps Multi Volt Stop/Tail/Indicator With 18 Square LEDs Twin Blister - 135ARM/2
2019 Honda CR‑V headlight bulbs
Based on Honda’s 2019 CR‑V Owner’s Manual, dealer workshop information and parts catalogues, headlight bulbs are absolutely relevant to this model. Most 2019 CR‑V grades use replaceable halogen bulbs, while upper trims feature LED headlight units. Even where LEDs are fitted, they’re still a headlight “bulb” functionally, just packaged as a sealed module that’s typically serviced as an assembly. That aligns with Australian Design Rules and NZ WOF requirements that the vehicle must have correctly operating low and high beams.
Headlight bulbs on the 2019 CR‑V do the heavy lifting after dark—throwing a clear, legal beam so the driver can see and be seen. Low beam handles everyday night driving without dazzling oncoming traffic, high beam pushes light further down the road for rural or poorly lit areas. On halogen-equipped variants, many use H11 for low beam and HB3/9005 for high beam, higher trims use factory LED units that deliver a whiter, longer‑lasting output.
Good servicing habits keep things sharp. Check the headlamps at least yearly—or before long trips—for brightness, colour match and beam aim. If one halogen bulb fails or looks tired, replace both sides together for an even spread of light. Always stick to the correct specification and ADR‑compliant brands, and never up‑rate the wattage without proper approvals. If the car has LED headlights, any failure or moisture ingress is usually a workshop job because the LED module is integrated.
- When replacing halogen bulbs: switch off, open the bonnet, access the rear of the headlamp, unplug the connector, twist the bulb out, and install the new one without touching the glass (use gloves). Refit the dust cap, reconnect, then test.
- After replacement: check beam aim on a flat surface. Poor aim can fail a WOF or roadworthy and reduce visibility.
- Typical lifespan: halogen 2–5 years depending on use, LEDs much longer but are non‑serviceable in most cases.
For Aussie and Kiwi conditions, quality bulbs from reputable brands (think ADR‑compliant options, including “+visibility” ranges) are a smart upgrade without going overboard. If considering an LED retrofit into a halogen housing, get advice first—beam pattern and legality matter.
Popular questions
What bulb types fit a 2019 Honda CR‑V?
It depends on the trim. Many halogen‑equipped 2019 CR‑V models take H11 low beam and HB3/9005 high beam. Upper trims with factory LEDs use sealed LED units that aren’t user‑serviceable. Always confirm against the Owner’s Manual or the build plate.
Can halogen headlights be swapped to LED on a 2019 CR‑V?
Not directly. Dropping LED capsules into halogen projectors can spoil the beam pattern and may breach ADR/NZ rules. If you want LED performance, use approved components or OE LED assemblies and have the beam aim checked professionally.
How often should headlight bulbs be replaced?
Replace halogens as soon as they dim, flicker or fail—many owners do both sides every 2–3 years for even light. LED units usually last much longer, if one plays up, it typically needs specialist diagnosis and the headlight assembly may be replaced.