Parts for your 2017 Subaru Exiga-Tail lights

2017 Subaru Exiga tail-lights

Tail-lights are absolutely fitted to the 2017 Subaru Exiga. This is confirmed by technical references including the Subaru Exiga/Exiga Crossover 7 Owner’s Manual (Lighting section), the Subaru Service Manual Body/Exterior – Rear Combination Light procedures, and compliance with lighting regulations such as ADR 13/00 (AU) and the NZ Land Transport Rule: Vehicle Lighting 2004, all of which require operational rear position lamps on road-going vehicles.

On the 2017 Exiga, the tail-lights form part of the rear combination lamp assembly. Their job is to make the wagon clearly visible from behind at night and in poor weather, while also housing brake, indicator, and reverse functions. Whether the vehicle runs conventional bulbs or integrated LEDs depends on trim and market, but the purpose is the same: clear, bright rear lighting that matches the vehicle’s width and is easy for following traffic to read.

As part of regular servicing, it’s smart to check the tail-lights every few months or before a WoF/roadworthy. A quick walk-around with the lights on and a tap of the brake pedal will confirm if everything’s glowing as it should. If a bulb is out, check the owner’s manual for the correct spec before replacing, if the vehicle uses LEDs for the tail function, the whole lamp assembly may need to be swapped when a section fails.

• Keep lenses clean: road grime dulls light output. A mild car wash solution and a soft cloth do the trick.
• Watch for condensation: a light mist after rain is common, but persistent water suggests a perished seal or a cracked lens that should be addressed to avoid corrosion.
• Check the plug and earth: intermittent lighting can be a loose connector or dirty earth, a dab of dielectric grease helps guard against moisture.
• Fuse first: if both sides are out, confirm the relevant fuse before chasing wiring.

Replacing the rear combination lamp on a 2017 Exiga is straightforward: open the tailgate, remove the inner trim caps, undo the retaining bolts, then pull the lamp rearwards to release the locating pins. Disconnect the harness, swap the bulb or fit the new assembly, refit the gasket squarely, and torque the bolts snug—not gorilla tight—to protect the plastic. Test all functions (tail, brake, indicator, reverse) before closing up. Done right, the Exiga’s tail-lights will stay bright, compliant, and ready for those long trans‑Tasman kilometres.

Popular questions about 2017 Subaru Exiga tail-lights

What bulb type does the 2017 Exiga use for the tail-light?
It varies by trim and market. Some 2017 Exiga models use conventional wedge bulbs for tail/stop functions, while others integrate LED modules. The definitive answer is in the vehicle’s owner’s manual or the label on the lamp body. If it’s LED, the tail function isn’t a user-serviceable bulb and typically requires replacing the lamp assembly if it fails.

Why is there moisture in my Exiga’s tail-light?
A light fog after a cold night or a wash can be normal and often clears as the lamp warms. Persistent pooling or droplets usually indicates a compromised seal, a hairline crack, or a missing vent cap. Resealing or replacing the gasket, or the entire lamp if cracked, prevents corrosion and keeps the light output crisp and legal.

Can I upgrade to LED tail-lights on my 2017 Exiga?
Yes, but choose assemblies designed for the Exiga and compliant with AU/NZ standards. Plug‑and‑play LED bulbs in incandescent housings can cause hyper‑flash or warning lights unless resistors or proper CANBUS-compatible solutions are used. Purpose-built replacement lamps are the cleanest path for a reliable, road-legal upgrade.