Parts for your 2017 Mitsubishi Eclipse cross-Tail lights

2017 Mitsubishi Eclipse Cross tail-lights

Yes, tail-lights are absolutely fitted to the 2017 Mitsubishi Eclipse Cross. Technical sources including the Mitsubishi Eclipse Cross Owner’s Manual and workshop literature (Lighting/Electrical sections) specify rear combination lamps as standard equipment, and both the Australian Design Rules for lighting and the NZ Land Transport Rule: Vehicle Lighting 2004 require rear position lamps on passenger vehicles. So tail-lights are relevant and essential on this model.

On the 2017 Eclipse Cross, the tail-lights form a distinctive rear signature while doing important safety work. They provide rear position lighting so the car’s visible at night, brighter stop-lamps to signal braking, indicators for turns and lane changes, reversing lamps for backing visibility, and (where fitted) a rear fog lamp for foul weather. Many ANZ-spec variants use LED elements for the tail/stop lamps, with some functions (like indicators or reverse) depending on trim level and market spec.

As part of servicing, keeping the tail-lights in top nick is simple and worthwhile. A quick walk-around after dark or in a shaded garage helps spot a weak globe, a failed LED, or a cracked lens early.

• Clean the lenses with mild car shampoo—avoid harsh solvents that can haze the plastic.
• Check all functions: tail, brake, indicators, reverse, and rear fog (if equipped). Ask a mate to press the brake while you watch.
• If a bulb is out, match the correct type and wattage listed in the Owner’s Manual. For LED modules, the assembly may be non-serviceable and require lamp replacement.
• Inspect for moisture. Light misting can be normal after rain, but standing water points to a failed seal or vent—address promptly.
• If a circuit’s dead, check the relevant fuse and connector before replacing parts.

1. Open the tailgate and remove the small trim covers to access the lamp fasteners.
2. Undo the screws/bolts, then slide the lamp rearwards to free the locating pins.
3. Disconnect the wiring plug. Replace the bulb or swap in the new lamp assembly.
4. Reconnect, test all functions, then refit and snug the fasteners without over-tightening.

Choose quality, ADR/NZ-compliant parts to keep brightness and beam pattern spot-on. This Eclipse Cross’ tail-lights aren’t just good-looking—they’re critical for being seen, signalling clearly, and staying road-legal across Australia and New Zealand.

FAQs

Are the 2017 Eclipse Cross tail-lights LED or traditional bulbs?
Most ANZ-spec models run LED tail and stop functions in the rear combination lamps, while indicators and reversing lamps can be bulb or LED depending on trim. The Owner’s Manual or a quick visual check will confirm what’s fitted to a particular vehicle.

Do the tail-lights need coding after replacement?
No coding is typically required. Whether swapping a bulb or a full LED assembly, it’s generally plug-and-play. After fitting, test every function—tail, brake, indicators, reverse, and rear fog (if equipped)—and you’re good to go.

Why is there condensation in the tail-light, and is it a problem?
Light fogging after rain or a wash can be normal as the lamp breathes. If water droplets pool or the lens stays foggy, the vent or seal may be compromised. Dry the housing, check seals and gaskets, and replace the lamp if moisture persists.