Parts for your 2015 Nissan Serena-Driveshafts

2015 Nissan Serena driveshafts

Based on technical references including the Nissan Serena C26 series service manual (Front Axle/Rear Axle/Propeller Shaft sections) and the Nissan genuine parts catalogue for C26/NC26 models, driveshafts are absolutely fitted to the 2015 Nissan Serena. Every front‑wheel‑drive Serena uses a pair of front CV axle shafts (left and right) from the transaxle to the wheel hubs, and 4WD variants add a centre propeller shaft to the rear differential plus rear axle shafts. The mild-hybrid (S-HYBRID) setup and CVT don’t change that—driveshafts remain the key link moving torque to the wheels.

On a 2015 Serena, the driveshafts do the heavy lifting: they carry engine torque from the CVT transaxle to the hubs while allowing for suspension travel and steering angle via constant velocity (CV) joints. On 4WD models, a balanced propeller shaft sends drive rearwards, supported by a centre bearing, with universal joints or couplings handling movement and alignment. Properly sealed CV boots keep high‑moly grease where it belongs and road grit out. When those boots crack, joints lose lubrication, wear accelerates, and tell‑tale noises start.

For servicing, a sensible routine in Australia and New Zealand is to inspect driveshafts with every tyre rotation or 10,000–15,000 km. Look for split boots, flicked grease on inner guards, torn boot clamps, and seepage at transaxle seals. Road test for:

• Clicking on tight turns (outer CV joint wear)
• Shudder or vibration under load (inner CV joint or prop shaft balance/centre bearing on 4WD)
• Clunks on take‑off (excess play in joints or splines)

If a boot is cracked, replacing the boot promptly can save the joint