Parts for your 2015 Honda Cr-v-Oil pump

2015 Honda CR‑V oil pump — what it does and how to look after it

Technical sources confirm the 2015 Honda CR‑V is fitted with an engine oil pump. The Honda Service Manual for the 2015 CR‑V (K24W, Lubrication System) describes a chain‑driven trochoid oil pump mounted at the front of the engine. Honda’s Electronic Parts Catalogue shows the complete oil pump assembly and pickup, and independent workshop information platforms (e.g., Alldata and Mitchell) publish removal and installation procedures. So yes — the oil pump is very much used on this model.

On the 2015 CR‑V, the oil pump’s job is to circulate engine oil under pressure through galleries to bearings, the timing chain and VTC components, keeping everything lubricated and cool. It’s driven off the crankshaft by a chain, and it draws oil through a strainer in the sump. When the pump’s doing its thing properly, the engine runs smoothly, quietly and for a very long time.

There’s no routine replacement interval for the oil pump — it’s designed to last the life of the engine. The smartest “maintenance” is simply keeping to the correct service schedule: use quality 0W‑20 oil that meets the spec in the owner’s manual and change it at the recommended intervals for Australian and New Zealand conditions. Clean oil protects the pump’s internals, the relief valve and the pickup screen from sludge, which is where most pump troubles begin.

If the oil pressure light comes on, don’t keep driving. First steps are always to check the oil level and condition, then have the pressure verified with a mechanical gauge. Many “oil pump faults” turn out to be a clogged pickup, the wrong viscosity oil, a tired pressure switch, or internal wear elsewhere. If the pump is genuinely worn or damaged, replacement is a workshop job that typically involves removing the sump, front cover and the pump’s drive, resealing with the correct engine sealant, swapping critical O‑rings, and priming the pump with fresh oil before start‑up.

• Signs of trouble: red oil pressure warning, persistent rattles from the front cover area, low oil pressure readings when hot, or metallic debris in the sump.
• Good practice at replacement: use OEM‑quality parts, renew the pickup O‑ring and seals, clean the strainer, and follow the service manual torque specs and timing/chain alignment marks.
• Typical workshop time: expect several hours of labour, costs vary by region, but it’s a job best left to experienced technicians.

Popular questions

Does the 2015 Honda CR‑V have an oil pump?
Yes. Factory documentation (Honda Service Manual, Lubrication System) and the Honda parts catalogue list a chain‑driven oil pump assembly on the 2015 CR‑V’s K‑series engine. It’s essential to the engine’s lubrication system.

When should the oil pump be replaced?
There’s no scheduled interval. It’s only replaced if testing shows low oil pressure that’s traced to the pump or its relief valve, or if there’s damage/contamination. Regular oil changes with the correct 0W‑20 oil go a long way to preventing issues.

How much does oil pump replacement cost in AU/NZ?
It varies with labour rates and parts choice, but expect several hours of labour plus seals, O‑rings, and the pump assembly. Ballpark totals often land in the low four figures (AUD/NZD). A proper diagnosis first can save unnecessary spend.