Parts for your 2015 Honda Accord-Headlight bulbs

2015 Honda Accord headlight bulbs — what they do and how to look after them

Based on Honda’s 2015 Accord Owner’s Manual and Honda service/parts catalogues, headlight bulbs are used on most 2015 Accord variants. The common setup is halogen low beam (H11) and halogen high beam (HB3/9005). An exception exists on some higher trims (e.g., Touring), which use an LED low‑beam headlamp module that isn’t a traditional replaceable bulb, that LED is serviced as a headlamp assembly. If you’ve got a non‑Touring model, “headlight bulbs” absolutely apply, if you’ve got a Touring with LED low beams, bulbs still apply to other lamps (e.g., high beam) but not that LED low beam.

Headlight bulbs do the heavy lifting for safe night driving, giving a clean cutoff for oncoming traffic while keeping the road ahead well lit. They’re essential for ADR/NZTA compliance and visibility in rain, fog and rural night runs. Over time, halogen bulbs lose brightness and shift colour, so output can drop long before a bulb actually fails.

• Typical bulb types: Low beam H11 (halogen), High beam HB3/9005 (halogen). Touring low beam uses an LED module (no separate bulb), per Honda service info.
• Tell‑tale signs it’s time: dim/yellowish light, flicker, one side out, or burnt connectors/caps behind the lamp.

Good servicing practice is to replace halogen bulbs in pairs so colour and brightness match. Stick with quality, ADR‑compliant bulbs. Avoid touching the glass—skin oils create hot spots and shorten life. After a swap, check beam aim, a quick headlamp alignment keeps you legal and avoids dazzling others.

1. Switch off, let things cool, and pop the bonnet. For low beams on most models, access is usually via the rear of the headlamp (some prefer turning the front wheel and going in through the inner guard for extra room).
2. Remove the rubber dust cap, unplug the connector, release the spring clip or twist the bulb holder, then withdraw the bulb.
3. Install the new bulb (don’t touch the glass), lock it in, reconnect, refit the dust cap, then test high/low beams.

Bulb life varies with use, but many drivers notice dimming after 2–3 years. If you drive a lot at night, consider preventative replacement around the 60–80,000 km mark. For LED low‑beam models (e.g., Touring), there’s no routine bulb replacement—diagnosis and repair involve the LED driver and headlamp assembly, typically handled with Honda dealer‑level service info and scan tools. And a quick legal note for AU/NZ: retrofitting LED or HID “conversion” bulbs into halogen housings is generally not road‑legal without certified modifications.

FAQs

What headlight bulbs fit a 2015 Honda Accord?

Most 2015 Accords use H11 for low beam and HB3/9005 for high beam. Some Touring models have an LED low beam that isn’t a replaceable bulb, if that’s yours, only the high beam uses a traditional bulb. Check the owner’s manual or the label behind the headlamp to confirm.

Can I upgrade to LED bulbs in my halogen headlights?

In Australia and New Zealand, plug‑in LED conversions in halogen housings are generally not road‑legal unless the headlamp is certified for that light source. For a legal and safe improvement, choose ADR‑compliant premium halogens or upgrade complete assemblies that are approved for LED.

Why do my headlight bulbs keep blowing?

Frequent failures can be caused by vibration, touching the glass during installation, over‑voltage/charging issues, or moisture in the housing. Inspect the dust caps and seals, check system voltage with the engine running, and use quality bulbs. Replace in pairs to keep output even.