Parts for your 2014 Toyota Land cruiser-Gas struts

2014 Toyota Land Cruiser Gas Struts

Gas struts are absolutely fitted to the 2014 Toyota Land Cruiser 200 Series. Technical sources including the Toyota Land Cruiser 200 Series Repair Manual (Body: Hood “Hood Support Damper” and Body: Back Door “Back Door Support Damper”) and the Toyota Electronic Parts Catalogue for J200 (2014 model year) specify gas‑charged support dampers on the bonnet and on the upper back door (the glass/lift section of the split tailgate). The lower tailgate section is cable‑supported and doesn’t use struts.

On this model, the gas struts do the heavy lifting. They counterbalance the weight of the bonnet and upper tailgate, making them easy to lift and steady to hold open, while also damping movement so nothing slams shut unexpectedly. That’s a nice blend of safety and convenience whether checking fluids under the bonnet or loading the boot out the back on a wet arvo.

During routine servicing, it’s smart to give the struts a quick once‑over. They’re sealed units, so there’s no topping up—replacement is the fix when they tire. Tell‑tale signs include the bonnet or tailgate dropping, lifting more slowly (especially in cold weather), needing a hand to stay up, or showing a light oily film around the rod seal. Any knocking, uneven extension, or a visible bend is another cue they’re due.

Replacement is straightforward but should be done safely. Always support the panel securely, then swap the struts one side at a time. Replace in pairs to keep lift and hold even, and match the correct force rating and stroke to the Land Cruiser’s spec. Install in the same orientation as the originals, avoid twisting the rod, and keep the chrome shaft clean—no pliers on the rod, no paint, and no grease on the shaft. A tiny dab of silicone lubricant on the ball studs is fine if recommended, but never contaminate the seal or rod.

Most owners find genuine or reputable aftermarket struts last many years—often 5–10 depending on climate and use. As part of regular servicing in Australia and New Zealand, a simple functional check—open, hold, and close—goes a long way. If there’s any doubt, new struts are a quick, cost‑effective upgrade that restores that new‑car feel to the big Cruiser’s bonnet and tailgate.

• Check operation at each service interval.
• Replace struts in pairs with the correct rating for the 200 Series.
• Support panels securely during replacement.

FAQs

Does the 2014 Land Cruiser have gas struts on both the bonnet and the tailgate?
Yes. Toyota’s 200 Series service literature and parts catalogue list gas‑charged dampers for the bonnet and for the upper back door of the split tailgate. The lower tailgate panel uses cables rather than struts.

How long do the gas struts typically last?
There’s no fixed interval, but many owners see 5–10 years from quality struts. Heat, cold, dust, and frequent use shorten life. Replace when the bonnet or tailgate won’t stay up confidently, rises slowly, or shows oil weep at the seal.

Can one strut be replaced on its own?
It’s best to replace them in pairs. Mixing an old and a new strut can cause uneven support and premature wear, and may not hold the panel securely—especially on a heavy tailgate or bonnet like the Land Cruiser’s.