Parts for your 2014 Toyota Land cruiser-Centre bearing

2014 Toyota Land Cruiser centre bearing — what it does and when to replace it

Yes, a centre bearing is used on the 2014 Toyota Land Cruiser. Technical sources that confirm this include the Toyota Repair Manual (propeller shaft section) for J200 and 70 Series, which illustrates a two-piece rear propeller shaft supported by a centre (carrier) bearing and bracket. The Toyota Electronic Parts Catalog also lists “Bearing Assy, Centre Support, Propeller Shaft” for 2014 Land Cruiser 200 (URJ/VDJ200) and 70 Series (VDJ76/78/79). Reputable driveline catalogues used in Australia and New Zealand (e.g., Hardy Spicer/Spicer, GMB) likewise catalogue centre support bearings for 2007–2015 LandCruiser models.

On a 2014 Land Cruiser, the centre bearing supports the two-piece rear driveshaft, keeping it aligned under load while the rubber isolator in the mount helps tame vibration and harshness. It’s there because the Land Cruiser’s long wheelbase and 4WD layout benefit from splitting the shaft into two sections — better angles, smoother operation and a tougher setup for towing, corrugations and off-road flex.

Owners will usually notice a worn centre bearing as a shudder on take-off or a low-speed drone that worsens under load. As the rubber perishes or the bearing gets rough, the shaft can’t stay centred, which shows up as vibration and extra wear on universal joints. While there’s no fixed replacement interval, it’s smart to inspect it during routine servicing, especially if the vehicle tows, carries loads, or spends time off-road.

• Typical signs it’s due: take-off shudder, humming/droning at 40–80 km/h, vibration under acceleration, visible cracks in the rubber, or excessive movement at the support bracket.
• Service check: look for split rubber, looseness in the mount, rust dust from the bearing, and oil contamination. Also check the uni joints and slip joint while you’re there.

When replacing, mark the driveshaft flanges and yokes before disassembly so the original phasing and balance are preserved. The bracket unbolts from the crossmember and the centre bearing is typically replaced as an assembly. Torque fasteners to the spec in the Toyota manual, and align the bracket square so the shaft runs true. If the Land Cruiser has a suspension lift, it’s worth checking driveline angles