Your Selected Vehicle
Parts for your 2014 Daihatsu Bego-Headlights
LED Autolamps Multi Volt Stop/Tail Lamp With Rubber Grommet And Plug - 164RM
LED Autolamps 12/24V Reverse Lamp Horizontal/Vertical Mount Twin Blister - 11WM-2
LED Autolamps 12/24V Cat6 Side Direction Indicator Clear Lens Blister Pack - 77ACM
LED Autolamps 12/24V Front End Outline Marker Recessed Fitting Twin Blister - 7922WM2
Explore 4WD & Adventure
LED Autolamps 24V Front Indicator And Park Light Chrome Bezel Blister Pack - 285CAW24
LED Autolamps 12V Stop/Tail/Indicator/Licence Plate Lamp With Reflector - 149BARL4P
LED Autolamps 174 Series Stop/Tail/Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174ARMB
LED Autolamps 174 Series Stop/Tail Lamp 12/24V, Surface Mount, 40cm Cable - 174RMB
LED Autolamps 174 Series Reverse Lamp 12/24V, Surface Mount, 40cm Cable - 174WMB
LED Autolamps Licence Plate Lamp Black Bracket Multi Volt With 1m Cable - 35BLM1P
LED Autolamps 10/30V LED Side Direction Indicator Light With 30cm Wire - 35AMB
LED Autolamps 12V Stop/Tail Lamp Black Chrome Round With Clear Lens - 102RBC
LED Autolamps 12V 82 Series Stop/Tail/Indicator/Reverse Lamp Black Bracket - 82BARW
LED Autolamps Multi Volt Stop/Tail/Indicator With 18 Square LEDs Twin Blister - 135ARM/2
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly 3 Lamps With 153 LEDs - 125BARWM
LED Autolamps 12/24 Multi Volt Stop/Tail/Indicator/Reverse Assembly Lamp With 108 LEDs - 80BARWM
LED Autolamps 12V Front Indicator Amber Lens Black Base Twin Blister Pack - 175A/2
LED Autolamps LHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284LHS
2014 Daihatsu Bego Headlights — Purpose, Care, and Replacement
Headlights are absolutely fitted to the 2014 Daihatsu Bego and are essential for road use. This is supported by the Daihatsu/Toyota J200-series owner’s and service manuals for Bego/Terios/Rush models, which detail headlamp operation and bulb specifications, and by legal fitment requirements under Australian Design Rules (ADR 13/00) and the New Zealand Vehicle Lighting Rule. So yes, headlights are relevant, used, and legally required on this vehicle.
On the 2014 Bego, the headlights provide forward illumination for night driving and low-visibility conditions, while making the vehicle visible to others. Most trims run halogen reflector units, typically using a dual-filament bulb for low and high beam. They’re simple, reliable, and easy to service, which suits everyday Aussie and Kiwi driving.
As part of regular servicing, the Bego’s headlights deserve a quick once-over. Halogen bulbs slowly dim with age, so even if they’re not blown, output can drop noticeably after a few years. Lenses also haze from UV exposure, and aim can drift thanks to potholes and rough roads.
- Check beam brightness and colour: if one side looks yellow or dull, replace both bulbs as a pair for balanced light.
- Inspect lenses: light hazing can be polished, deep cracks or heavy moisture may call for a replacement housing.
- Confirm aim: keep low beam set to avoid glare while giving solid forward reach, adjust after suspension or tyre changes.
- Keep it clean: wash with car shampoo and a soft microfibre, not harsh solvents that can craze the plastic.
- Use correct bulbs: stick to the specified wattage and cap type for ADR/NZ compliance and to protect the wiring.
DIY bulb swap is straightforward under the bonnet: unplug the connector, pop the dust cover, release the spring clip, and lift the bulb out. Avoid touching the glass with bare fingers. Seat the new bulb properly, refit the clip and dust cover, and test both beams. If there’s a headlight levelling dial inside the cabin, set it correctly after loading the car. For persistent condensation, check the vent caps and seals, small misting after rain is normal, but pooled water isn’t.
Need a hand? A quick bulb refresh and aim check can make night drives feel brand new, and it’s a tidy upgrade to safety for not much coin.
Popular questions about 2014 Daihatsu Bego headlights
What bulb type does the 2014 Bego use?
Most 2014 Bego models use a dual‑filament halogen (commonly H4 12V 60/55W) in reflector housings. Some market trims can vary. It’s best to confirm against the owner’s manual or the existing bulb’s markings and stick with the factory wattage for compliance and wiring health.
How often should the headlights be replaced?
Halogen bulbs can lose 20–30% brightness over a couple of years. Many owners replace every 2–4 years or at the first sign of dimming. Always replace in pairs so both sides match colour and output, and check the aim after fitting.
Why is there condensation inside the headlight?
Light misting after wet weather can be normal due to vented housings. If moisture lingers or there’s visible pooling, look for blocked vents, a perished seal, or a hairline crack. Sorting the cause early prevents reflector tarnish and keeps beam quality sharp.