Your Selected Vehicle
Parts for your 2013 Suzuki Splash-Batteries
Explore 4WD & Adventure
LED Autolamps 12V Black Chrome Round Indicator Lamp With Clear Lens - 102ABC
LED Autolamps 12/24V LED Number Plate Light LED With 0.14M Lead (2 pce) - 30BLM
LED Autolamps Multi Volt Stop/Tail/Ind/Rev With Try Me Function Diffused Tail With Sequential Indicator Twin Blister - 385ARWM-2
LED Autolamps 12V Stop/Tail Strip Lamp With 10 Square LEDs Recessed Mount - 235R12
LED Autolamps 12V Stop/Tail/Indicator Lamp With Reflector 100x100x22mm - 101BAR
LED Autolamps 12/24V LED Stop/Tail Lamp With Red Lens Round With Grommet/Plug - 113RMG
LED Autolamps 12V LED Stop/Tail/Indicator/Licence Plate Lamp with Reflex Reflector - 99ARL
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse/Reflector LHS & RHS Diffused Tail Light - 284ARWM-2
LED Autolamps 12V LED Stop/Tail/Indicator Lamps With Reflector Twin Blister - 101BAR2
LED Autolamps 12/24V Amber Marker Clear Lens Coloured LEDs Stainless Steel Bezel - 86AM
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Amber Red LED Light - 282ARWM
LED Autolamps 10/30V Rear Position Marker 2 Red LEDs With 40cm Wire Blister Pack - 58RM
LED Autolamps 12/24V LED Stop/Tail/Indicator/Reverse Lamp 200x50x28mm Twin Blister - 200BIRSTME2
LED Autolamps 12V Indicator Strip Lamp With 10 Square LEDs Recessed Mount - 235A12
LED Autolamps 12/24V LED Stop/Tail/Indicator/Licence LED Light With 4 Pin Plug - 99ARLM4P
2013 Suzuki Splash batteries: purpose, care, and replacement
Per the 2013 Suzuki Splash owner’s manual (Electrical/Battery section) and mainstream battery fitment catalogues from brands like Yuasa and Bosch, the Splash is factory-fitted with a 12‑volt lead‑acid starting battery. So yes, batteries absolutely apply to the 2013 Suzuki Splash.
The battery’s job is straightforward but critical: it cranks the 1.0–1.2‑litre engine, powers the ECU, fuel pump, lights, immobiliser, and accessories when the alternator isn’t spinning, and smooths the electrical supply while driving. Without a healthy battery, the Splash can be hard to start, idle roughly after a jump-start, or throw up warning lights due to low system voltage.
For servicing, a battery check is a smart inclusion at each service interval. In Aussie and Kiwi conditions, most lead‑acid batteries last around 3–5 years. Signs it’s getting tired include slower cranking, dim interior lights, a clock or radio that keeps resetting, or needing frequent jump‑starts. If the car does lots of short hops around town, consider a periodic top‑up charge with a smart charger to keep it in good nick.
When replacing, match the original spec: 12 V, the correct case size and terminal layout for the Splash’s tray, and suitable cold‑cranking amps (CCA) for the engine and climate. Many petrol Splash models take a compact JIS‑style unit, always verify polarity and dimensions against the old one or the owner’s manual. Unless the vehicle specifically has stop/start (uncommon on Splash), a quality maintenance‑free lead‑acid or EFB unit is fine, AGM is only required for vehicles designed for it.
Fitment tips under the bonnet: preserve memory with a support pack if available, turn everything off, then remove the negative cable first and refit it last. Clean any white/green corrosion with a bicarb‑and‑water solution, tighten clamps firmly, and apply a light smear of terminal protectant. After installation, reset the clock and radio presets, let the engine idle for a few minutes so the ECU can relearn.
To stretch battery life, keep the terminals clean, secure the hold‑down bracket so the case can’t vibrate, and give the car a decent run (or a smart‑charger session) if it’s been sitting. Recycle the old battery properly—most parts stores in AU/NZ will take it.
- Typical lifespan: 3–5 years in AU/NZ climates
- Check CCA, case size, and terminal orientation before buying
- Charge fully if the car only does short trips
FAQs
What battery type and size fits a 2013 Suzuki Splash?
Most 2013 Splash models use a compact 12‑volt lead‑acid battery in a small JIS‑style case. Many fitment guides list the B19/NS40 family for petrol trims, but owners should confirm polarity, dimensions, hold‑down, and CCA against the existing battery or the owner’s manual to be sure.
How long should a Splash battery last in Australia or New Zealand?
Typically 3–5 years. Heat, short trips, and accessories left on can shorten life. A healthy charging system, clean terminals, and an occasional smart‑charger top‑up can push it towards the upper end of that range.
Does the Splash need an AGM battery?
Generally, no. Most 2013 Suzuki Splash variants don’t use idle stop/start, so a standard maintenance‑free lead‑acid (or EFB) is appropriate. Only vehicles specifically equipped for stop/start should run AGM or EFB as specified in the manual.