Parts for your 2013 Honda Stream-Brake hose

2013 Honda Stream brake hose: what it does and how to look after it

Yes — the 2013 Honda Stream uses flexible brake hoses. Honda’s service literature for the RN6–RN9 Stream platform and the official Honda Electronic Parts Catalogue list flexible front and rear brake hoses at each corner (often labelled “Hose, FR. Brake” and “Hose, RR. Brake”), joined by banjo bolts at the calipers/wheel cylinders and clipped to the chassis hard lines. These factory sources, echoed by dealer parts diagrams and reputable aftermarket catalogues, confirm the brake hose is very much a fitted and serviceable component on this model.

On the 2013 Stream, the brake hose’s job is simple but critical: carry high‑pressure brake fluid from the rigid chassis lines to the moving bits — the front calipers and the rear calipers or wheel cylinders — while coping with steering and suspension travel. The hose is built from layered rubber with reinforcement (or upgraded braided stainless types) so it can flex constantly without bursting. If a hose swells, cracks, leaks, or collapses internally, pedal feel goes spongy, braking can pull to one side, or a wheel may drag as pressure can’t release. None of that is fun, and it’s not safe.

As part of regular servicing, the brake hoses deserve a close look at least every service or 10,000–15,000 km. They should be checked for surface cracking, wetness or weeping, bulges under pedal pressure, chafe marks at clips, and twisted routing after previous work. While there’s no fixed replacement age, many techs in Australia and New Zealand treat hoses as lifecycle items from around the 8–12 year mark, especially if the car sees heat, UV, road grime, or coastal conditions.

Replacement is straightforward for a competent technician: support the line to avoid kinks, use flare‑nut spanners on the hard‑line fittings, swap copper sealing washers at the banjo, route the hose through all factory brackets without twists, and torque to Honda spec. Bleed the system with the brake fluid type shown on the reservoir cap (typically DOT 3 for this model) and confirm a firm, even pedal. If choosing braided stainless hoses, ensure they’re ADR/WoF compliant and properly certified