Your Selected Vehicle
Filter
Filter By
Parts for your 2013 Holden Commodore-Headlights
LED Autolamps 12/24V LED MaxiLamp Stop/Tail/Indicator/Reflector Light Round Blister Pack - MAXILAMP1XC
LED Autolamps Rear combination L/R tail lights with sequential indicator, Chrome, Twin Blister - 355ARWM-2
LED Autolamps 12V/24V LED Stop/Tail/Indicator Lamp with Black Bracket - 200BSTIM
Explore 4WD & Adventure
LED Autolamps 12/24V LED Number Plate Light LED With 0.14M Lead (2 pce) - 30BLM
LED Autolamps Multi Volt Stop/Tail/Ind/Rev With Try Me Function Diffused Tail With Sequential Indicator Twin Blister - 385ARWM-2
LED Autolamps 12V Stop/Tail Strip Lamp With 10 Square LEDs Recessed Mount - 235R12
LED Autolamps 12V Stop/Tail/Indicator Lamp With Reflector 100x100x22mm - 101BAR
LED Autolamps 12/24V LED Stop/Tail Lamp With Red Lens Round With Grommet/Plug - 113RMG
LED Autolamps 12V LED Stop/Tail/Indicator/Licence Plate Lamp with Reflex Reflector - 99ARL
LED Autolamps Multi Volt Stop/Tail/Indicator/Reverse/Reflector LHS & RHS Diffused Tail Light - 284ARWM-2
LED Autolamps 12V LED Stop/Tail/Indicator Lamps With Reflector Twin Blister - 101BAR2
LED Autolamps 12/24V Amber Marker Clear Lens Coloured LEDs Stainless Steel Bezel - 86AM
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Amber Red LED Light - 282ARWM
LED Autolamps 10/30V Rear Position Marker 2 Red LEDs With 40cm Wire Blister Pack - 58RM
LED Autolamps 12/24V LED Stop/Tail/Indicator/Reverse Lamp 200x50x28mm Twin Blister - 200BIRSTME2
LED Autolamps 12/24V LED Stop/Tail/Indicator/Licence LED Light With 4 Pin Plug - 99ARLM4P
LED Autolamps 12V Indicator Strip Lamp With 10 Square LEDs Recessed Mount - 235A12
LED Autolamps 12V LED Boat Trailer Lamps Stop/Tail/Indicator with Licence Plate Lamp Light Left & Right Side, with 8m cable, Twin Blister - 209GARLP2/8M
LED Autolamps 12/24V Stop/Tail/Indicator Light Clear Lens Coloured LEDs Surface Mount - 12ARM-2
LED Autolamps 12/24V Maxilamp Stop/Tail/Indicator/Reverse/Reflector Combo Lamp Black Chrome - MAXILAMPC3XRWB
LED Autolamps 10/30V Side Direction Indicator In Blister Pack With 3 LEDs - 58AM
LED Autolamps 12V 2x Stop/Tail/Indicator Boat Trailer Lamps with Licence Plate Lamp, includes Left & Right Side - 207BARLP2
LED Autolamps 12V LED Stop/Tail/Indicator Lamp With Licence Plate Lamp Blister Pack Containing Left & Right Lamps - 99ARL2
LED Autolamps 12/24V 280 Mini Jumbo Stop/Tail/Indicator/Reverse LED Light Blister Pack - 280ARWM
LED Autolamps 12V LED Stop/Tail/Indicator Lamp With Reflector 150x80x22M - 151BAR
LED Autolamps Twin function front position with supplementary front indicator - 97WIMCSB
2013 Holden Commodore Headlights
Headlights are absolutely fitted to the 2013 Holden Commodore. Under Australian Design Rules (ADR 13/00 for lighting installation and ADR 46/00 for headlamps), all passenger vehicles must have compliant headlamps. New Zealand requirements are similar under the Land Transport Rule: Vehicle Lighting 2004. So headlights aren’t just relevant—they’re mandatory and a core safety system on this model.
On a 2013 Commodore, the headlights do the heavy lifting at dusk, night, and in poor weather. Low beam is tuned to give a wide, even spread without dazzling oncoming traffic, while high beam throws light further down the road for open-road visibility. Many trims use halogen projector units, and some variants pair them with LED daytime running lamps—handy for being seen, but DRLs aren’t a substitute for proper headlights.
As part of regular servicing of the 2013 Holden Commodore’s headlights, it pays to keep a simple routine. Replace bulbs in pairs so brightness and colour match. Avoid touching halogen glass with bare fingers—oils can shorten bulb life. Keep the lenses clean with pH-neutral car wash and a soft cloth, if the lenses look yellow or cloudy, a proper restoration kit or professional refinish can bring back clarity.
Moisture or fogging inside the unit usually points to a tired seal or cracked cap—sort that early to prevent corrosion on connectors. If a light is out, check the relevant fuse and relay before ordering parts. After any bulb change, confirm the aim, most Commodores include a leveling adjustment, but workshop alignment ensures the beam pattern meets ADR/NZ standards and doesn’t glare other drivers.
- Watch for signs it’s time: dim output, flickering, visible lens haze, or moisture.
- During replacement, secure the dust cap properly, route the wiring as found, and use quality, ADR-compliant parts.
- Have the headlights inspected at every service or roughly every 10,000–15,000 km, bulbs typically last 2–4 years depending on use.
Looked after, the Commodore’s headlights will give confident, legal illumination—making night drives feel easy and keeping WOF/roadworthy checks stress-free.
Popular questions about 2013 Holden Commodore headlights
What headlight bulbs does a 2013 Commodore use?
It varies by trim and whether the car has projector low beams or any premium lighting package. Many use halogen bulbs for both low and high beam. The safest bet is to check the owner’s manual or parts guide by VIN to confirm exact fitment before buying.
Can LED or HID upgrades be fitted legally?
Only if the parts comply with ADR/NZ rules and are installed to maintain the correct beam pattern without glare. That usually means using purpose-designed, compliant assemblies. After any upgrade, have the aim checked professionally to keep things legal and safe.
How do you fix cloudy or yellowed headlight lenses?
Light haze can be polished with a quality restore kit that includes UV sealant. Heavier oxidation often needs a professional refinish. Keeping lenses clean and protected with a UV-safe sealant helps them stay clear longer.