Your Selected Vehicle
Parts for your 2013 Holden Commodore-Headlights
LED Autolamps 12/24V Amber LED Emergency Lamp With Strobe Permanent Mount - 93AM
LED Autolamps 12V Sequential Indicator Strip Light 10 Square LEDS Amber Lens Blister Pack - 235ASEQ-2
LED Autolamps Trailer Connector Gooseneck To Car With 7 Pin Large Round Plug 1m Cable - 5C81B
LED Autolamps 10/30V LED Side Direction Indicator Light With 3m Tinned Cable - 58AM3
Explore 4WD & Adventure
LED Autolamps 12V Slimline/Low Profile Reverse Lamp with Black End Caps - 285BW12
LED Autolamps 90 Series Amber Emergency LED Strobe/Warning Light 12V/24V Surface Mount - 90AM
LED Autolamps 12/24V LED Stop/Tail/Indicator/Licence LED Light With 4 Pin Plug - 99ARLM4P
LED Autolamps 12V Sequential Indicator Strip Light 10 Square LEDS Amber Lens Bulk Packaging - 235ASEQB
LED Autolamps 10/30V Rear Position Marker 2 Red LEDs With 40cm Wire Blister Pack - 58RM
LED Autolamps 12V Stop/Tail/Ind/Rev LED Light Kit 450mm Loom DT04 Connector - SO282ARWM2LR450
LEDAUT 12V LED Interior Light 61PCS SMD LEDs Clear Lens With White Frame Blister Pack - 1061
LED Autolamps 10/30V Front Outline Position Marker 4 White LEDs With 40cm Wire - 35WM
LED Autolamps 12/24V Stop/Tail/Indicator/Reflector With Licence Plate Lamp - 99ARLM
LED Autolamps 12/24V Amber Emergency Mini Light Bar 18 Selectable Flash Patterns Magnetic Mount - LB246ACMM
LED Autolamps 385 Series Rear Combination Lamp LHS with 7 core plug - 385ARWMLCSB
LED Autolamps 12V LED Stop/Tail/Indicator Lamp With Reflex Reflector White Background - 150BAR
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly With 123 LEDs - 100BARWM
LED Autolamps 12/24V LED Rear Combination Stop/Tail/Indicator/Reverse Light with Reflectors, Blister Pack - 250ARWM
LED Autolamps 12V Stop/Tail/Indicator/Licence Plate Lamp With Reflector - 149BARL4P
2013 Holden Commodore Headlights
Headlights are absolutely fitted to the 2013 Holden Commodore. Under Australian Design Rules (ADR 13/00 for lighting installation and ADR 46/00 for headlamps), all passenger vehicles must have compliant headlamps. New Zealand requirements are similar under the Land Transport Rule: Vehicle Lighting 2004. So headlights aren’t just relevant—they’re mandatory and a core safety system on this model.
On a 2013 Commodore, the headlights do the heavy lifting at dusk, night, and in poor weather. Low beam is tuned to give a wide, even spread without dazzling oncoming traffic, while high beam throws light further down the road for open-road visibility. Many trims use halogen projector units, and some variants pair them with LED daytime running lamps—handy for being seen, but DRLs aren’t a substitute for proper headlights.
As part of regular servicing of the 2013 Holden Commodore’s headlights, it pays to keep a simple routine. Replace bulbs in pairs so brightness and colour match. Avoid touching halogen glass with bare fingers—oils can shorten bulb life. Keep the lenses clean with pH-neutral car wash and a soft cloth, if the lenses look yellow or cloudy, a proper restoration kit or professional refinish can bring back clarity.
Moisture or fogging inside the unit usually points to a tired seal or cracked cap—sort that early to prevent corrosion on connectors. If a light is out, check the relevant fuse and relay before ordering parts. After any bulb change, confirm the aim, most Commodores include a leveling adjustment, but workshop alignment ensures the beam pattern meets ADR/NZ standards and doesn’t glare other drivers.
- Watch for signs it’s time: dim output, flickering, visible lens haze, or moisture.
- During replacement, secure the dust cap properly, route the wiring as found, and use quality, ADR-compliant parts.
- Have the headlights inspected at every service or roughly every 10,000–15,000 km, bulbs typically last 2–4 years depending on use.
Looked after, the Commodore’s headlights will give confident, legal illumination—making night drives feel easy and keeping WOF/roadworthy checks stress-free.
Popular questions about 2013 Holden Commodore headlights
What headlight bulbs does a 2013 Commodore use?
It varies by trim and whether the car has projector low beams or any premium lighting package. Many use halogen bulbs for both low and high beam. The safest bet is to check the owner’s manual or parts guide by VIN to confirm exact fitment before buying.
Can LED or HID upgrades be fitted legally?
Only if the parts comply with ADR/NZ rules and are installed to maintain the correct beam pattern without glare. That usually means using purpose-designed, compliant assemblies. After any upgrade, have the aim checked professionally to keep things legal and safe.
How do you fix cloudy or yellowed headlight lenses?
Light haze can be polished with a quality restore kit that includes UV sealant. Heavier oxidation often needs a professional refinish. Keeping lenses clean and protected with a UV-safe sealant helps them stay clear longer.