Parts for your 2012 Honda Stream-Brake hose

2012 Honda Stream Brake Hose — Purpose, Care, and When to Replace

Based on Honda’s RN6–RN9 (2006–2014) Stream service information and the Honda Electronic Parts Catalogue, the 2012 Honda Stream is fitted with flexible brake hoses at each wheel. The factory workshop manual’s Brake System/Hydraulic Lines section details hose routing and bleeding, and the parts listings include front and rear flexible brake hose assemblies and clips. So yes, a brake hose absolutely applies to this model, and it’s a critical link in the hydraulic braking system.

The brake hose connects the rigid brake line on the chassis to the moving components at the wheel, allowing suspension and steering movement without stressing the hydraulic circuit. Built with a fluid-compatible inner liner and reinforced outer layers, it safely carries high-pressure brake fluid from the master cylinder to the callipers (and rear wheel cylinders where applicable), helping deliver a firm, predictable pedal and even braking.

Over time, hoses can crack, chafe, corrode at fittings, or degrade internally. Internal swelling or partial collapse is sneaky — it can cause a soft pedal, a pull under braking, or brakes that don’t release cleanly. Any fluid leak or hose “ballooning” is unsafe and will fail a WOF/roadworthy.

• Check for perishing, cracking, wetness, or rusted ferrules at every service.
• Look for kinks or rubbing marks at full lock and full suspension travel.
• Watch for a pull under braking, uneven pad wear, or a dragging wheel.
• Replace immediately if there’s any leak, bulge, or exposed braid.

For typical Australian and New Zealand use, have the hoses inspected at each service and consider proactive replacement around 6–10 years or 100,000–150,000 kilometres, sooner if the vehicle sees coastal conditions, gravel roads, or heavy loads. Fresh brake fluid (DOT 3 or DOT 4 as marked on the reservoir cap) helps reduce internal hose degradation.

When replacing, use quality, ADR/UN-compliant parts, renew copper crush washers, and route the hose exactly as per the clips and guides. Avoid twisting the hose