Your Selected Vehicle
Parts for your 2011 Toyota Land cruiser-Batteries
LED Autolamps Multi Volt Stop/Tail/Indicator With 18 Square LEDs Twin Blister - 135ARM/2
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIM
LED Autolamps 12/24V LED Reverse Lamp Screw Surface Mount Blister Pack - 12WM-2
Explore 4WD & Adventure
LED Autolamps 12/24V Reversing Lamp With 25 White LEDs With Bracket and 30cm Wire - 100WM
LED Autolamps MultiVolt R.H.S Stop/Tail/Indicator Assembly 128 Round LEDs - 125BARMR
LED Autolamps 12V Stop/Tail/Indicator/Reverse Assembly Chrome Bracket Blister Pack - 82CARRW
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly 3 Lamps With 153 LEDs - 125BARWM
LED Autolamps RHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284RHS
LED Autolamps 12V LED Stop/Tail/Indicator/Reverse Assemnly Lamp With 108 LEDs - 80BARW
LED Autolamps Twin function rear position with supplementary rear indicator - 97CRIM
LED Autolamps Front End Outline Marker White 12/24Vwith 2P plugs 10cm cable - 58WMB2P
LED Autolamps 12/24V LED Stop/Tail/Indicator Light 284x100x27mm Blister Pack - 282ARRM
LED Autolamps Twin function front position with supplementary front indicator - 97WIM
LED Autolamps 10/30V Front Outline Position Marker 4 White LEDs With 40cm Wire - 35WM
LED Autolamps 12/24 Multi Volt Stop/Tail/Indicator/Reverse Assembly Lamp With 108 LEDs - 80BARWM
LED Autolamps Multi Volt LED Licence Plate Lamp With Chrome Base Twin Blister - 30CLM
LED Autolamps 12/24V Round Indicator Lamp With Clear Lens 130mm Diameter Recessed Mount - 102ACM
2011 Toyota Land Cruiser batteries
Yes, batteries are absolutely relevant to the 2011 Toyota Land Cruiser. Toyota’s 2011 Owner’s Manual and Repair Manual for the 200 Series specify a 12‑volt lead‑acid starting battery, many AU/NZ diesel variants (1VD‑FTV) are factory‑fitted with twin 12‑volt batteries wired in parallel for higher cold‑cranking capacity and accessory support.
On this Cruiser, the battery’s job is to crank the big V8, stabilise the electrical system, and keep essentials alive when the engine’s off—think ECU memory, immobiliser and clock. Dual‑battery diesel models also better handle winches, fridges and touring gear without leaving drivers stranded. Whether single or twin, a healthy battery makes every start under the bonnet feel effortless.
As part of regular servicing, smart owners (and workshops) will:
- Load‑test the battery/batteries and check resting voltage (aim for ~12.6 V when fully charged).
- Verify alternator output (typically ~13.8–14.5 V at idle with accessories off).
- Inspect terminals, clamps and earths, clean any corrosion and ensure the hold‑down is secure.
- For dual setups, confirm the isolator/voltage‑sensing relay is operating correctly.
Replacement is straightforward, but a few Land Cruiser‑specific tips help. Choose a quality unit with ample CCA—N70‑size is common on diesel models, with AGM a popular upgrade for off‑road and accessory use. Replace dual batteries as a matched pair (same brand, age, capacity) to avoid uneven charging. Petrol models generally run a single 12‑volt battery, verify size and terminal layout against the tray and clamp.
When swapping batteries, keep the vehicle powered with a memory saver if possible. After reconnecting, expect to reset the clock and radio presets, reinitialise auto‑up windows if needed. Tighten terminals snugly (don’t overdo it), and always recycle the old battery properly. Typical life is 3–5 years, shorter if the vehicle does lots of short trips or heavy accessory duty. If cranking slows, lights pulse at idle, or there’s a rotten‑egg whiff near the battery, it’s time for a test.
For touring rigs, consider a dedicated auxiliary battery with a DC‑DC charger to protect the start battery. That way, the Cruiser stays ready for the next big kilometre, whether it’s the daily school run or a corrugated desert track.
FAQs
Does the 2011 Land Cruiser come with dual batteries from factory?
Many AU/NZ 1VD‑FTV diesel 200 Series models are factory‑fitted with twin 12‑volt batteries in parallel. Petrol variants are typically single‑battery. A quick look under the bonnet or a check of the Owner’s Manual will confirm the setup on a specific vehicle.
What battery type and size should be used?
Diesel models commonly use an N70‑size with high CCA (often 750–900+). AGM is a solid upgrade for heavy accessory loads. Petrol models may use a different size depending on market and tray/clamp layout. Always match case size, terminal orientation and hold‑down fit, and follow Toyota specifications.
How long will the battery last, and how can it be extended?
Expect roughly 3–5 years. Life improves with regular longer drives, clean terminals, correct alternator output, and avoiding deep discharges. On dual‑battery setups, a quality isolator or DC‑DC charger helps protect the start battery from camping loads.