Your Selected Vehicle
Parts for your 2011 Toyota Land cruiser-Batteries
LED Autolamps Twin function side indicator with amber/red side marker - 97CARIMCSB
LED Autolamps 12/24V Cat6 Side Direction Indicator Clear Lens Blister Pack - 77ACM
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Lamp 460x130x33mm - 460ARWM
Explore 4WD & Adventure
LED Autolamps 12/24V Reverse Lamp Horizontal/Vertical Mount Twin Blister - 11WM-2
LED Autolamps 24V Front Direction Indicator With Front Position Lamp Chrome Bracket - 200CAW/24
LED Autolamps 12V Stop/Tail Lamp Black Chrome Round With Clear Lens - 102RBC
LED Autolamps 12V Front Indicator Amber Lens Black Base Twin Blister Pack - 175A/2
LED Autolamps LHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284LHS
LED Autolamps Multi Volt Stop/Tail Lamp With Rubber Grommet And Plug - 164RM
LED Autolamps 12V 82 Series Stop/Tail/Indicator/Reverse Lamp Black Bracket - 82BARW
LED Autolamps 12V Stop/Tail/Indicator/Licence Plate Lamp With Reflector - 149BARL4P
LED Autolamps Licence Plate Lamp Black Bracket Multi Volt With 1m Cable - 35BLM1P
LED Autolamps 12V Stop/Tail/Indicator Lamp Reflector With 4 Pin Plug - 149BAR4P
LED Autolamps 12/24V Round Stop/Tail Lamp With Clear Lens 130mm Diameter Recessed Mount Blister Pack - 102RCM
LED Autolamps 12/24 Multi Volt Stop/Tail Lamp 36 LEDs With 40cm Wire - 80RM
LED Autolamps 12V/24V Round LED Stop/Tail Lamp With Grommet and Plug - 110RMG
2011 Toyota Land Cruiser batteries
Yes, batteries are absolutely relevant to the 2011 Toyota Land Cruiser. Toyota’s 2011 Owner’s Manual and Repair Manual for the 200 Series specify a 12‑volt lead‑acid starting battery, many AU/NZ diesel variants (1VD‑FTV) are factory‑fitted with twin 12‑volt batteries wired in parallel for higher cold‑cranking capacity and accessory support.
On this Cruiser, the battery’s job is to crank the big V8, stabilise the electrical system, and keep essentials alive when the engine’s off—think ECU memory, immobiliser and clock. Dual‑battery diesel models also better handle winches, fridges and touring gear without leaving drivers stranded. Whether single or twin, a healthy battery makes every start under the bonnet feel effortless.
As part of regular servicing, smart owners (and workshops) will:
- Load‑test the battery/batteries and check resting voltage (aim for ~12.6 V when fully charged).
- Verify alternator output (typically ~13.8–14.5 V at idle with accessories off).
- Inspect terminals, clamps and earths, clean any corrosion and ensure the hold‑down is secure.
- For dual setups, confirm the isolator/voltage‑sensing relay is operating correctly.
Replacement is straightforward, but a few Land Cruiser‑specific tips help. Choose a quality unit with ample CCA—N70‑size is common on diesel models, with AGM a popular upgrade for off‑road and accessory use. Replace dual batteries as a matched pair (same brand, age, capacity) to avoid uneven charging. Petrol models generally run a single 12‑volt battery, verify size and terminal layout against the tray and clamp.
When swapping batteries, keep the vehicle powered with a memory saver if possible. After reconnecting, expect to reset the clock and radio presets, reinitialise auto‑up windows if needed. Tighten terminals snugly (don’t overdo it), and always recycle the old battery properly. Typical life is 3–5 years, shorter if the vehicle does lots of short trips or heavy accessory duty. If cranking slows, lights pulse at idle, or there’s a rotten‑egg whiff near the battery, it’s time for a test.
For touring rigs, consider a dedicated auxiliary battery with a DC‑DC charger to protect the start battery. That way, the Cruiser stays ready for the next big kilometre, whether it’s the daily school run or a corrugated desert track.
FAQs
Does the 2011 Land Cruiser come with dual batteries from factory?
Many AU/NZ 1VD‑FTV diesel 200 Series models are factory‑fitted with twin 12‑volt batteries in parallel. Petrol variants are typically single‑battery. A quick look under the bonnet or a check of the Owner’s Manual will confirm the setup on a specific vehicle.
What battery type and size should be used?
Diesel models commonly use an N70‑size with high CCA (often 750–900+). AGM is a solid upgrade for heavy accessory loads. Petrol models may use a different size depending on market and tray/clamp layout. Always match case size, terminal orientation and hold‑down fit, and follow Toyota specifications.
How long will the battery last, and how can it be extended?
Expect roughly 3–5 years. Life improves with regular longer drives, clean terminals, correct alternator output, and avoiding deep discharges. On dual‑battery setups, a quality isolator or DC‑DC charger helps protect the start battery from camping loads.