Your Selected Vehicle
Parts for your 2011 Suzuki Splash-Batteries
LED Autolamps Front Marker LED White With Reflector 12-24V Perm Mnt - EU38WMHD
Explore 4WD & Adventure
LED Autolamps 10/30V Front Outline Position Marker 4 White LEDs With 40cm Wire - 35WM
LED Autolamps 12V Stop/Tail/Indicator/Reverse Assembly Chrome Bracket Blister Pack - 82CARRW
LED Autolamps Front End Outline Marker White 12/24Vwith 2P plugs 10cm cable - 58WMB2P
LED Autolamps 12/24V Round Indicator Lamp With Clear Lens 130mm Diameter Recessed Mount - 102ACM
LED Autolamps MultiVolt R.H.S Stop/Tail/Indicator Assembly 128 Round LEDs - 125BARMR
LED Autolamps Twin function side indicator with amber/red side marker - 97ARIMB
LED Autolamps 12V LED Stop/Tail/Indicator/Reverse Assemnly Lamp With 108 LEDs - 80BARW
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIMB
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly With 123 LEDs - 100BARWM
LED Autolamps Multi Volt LED Licence Plate Lamp With Chrome Base Twin Blister - 30CLM
LED Autolamps RHS, Stop/Tail/SEQ-Indicator/Reverse/Reflector 12/24V 284 X 100 X 37mm, DT04 Connector - SO284RHS
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Assembly 3 Lamps With 153 LEDs - 125BARWM
LED Autolamps 12/24V LED Stop/Tail/Indicator Light 284x100x27mm Blister Pack - 282ARRM
LED Autolamps Twin function rear position with supplementary rear indicator - 97CRIM
LED Autolamps Twin function front position with supplementary front indicator - 97WIM
2011 Suzuki Splash batteries
Based on Suzuki’s 2011 Splash owner’s manual and the factory workshop/parts catalogue for K10B and K12B models, this vehicle is fitted with a conventional 12‑volt automotive starter battery. So yes, a battery is absolutely relevant on a 2011 Suzuki Splash.
The battery’s job is to crank the engine, power the engine management, fuel system and safety electronics, and keep lights, locks and accessories alive when the engine’s off. It also stabilises voltage while the alternator is charging on the move. On any Splash variant that’s equipped with idle stop/start, the battery works even harder, demanding an EFB or AGM design to handle frequent restarts.
For everyday servicing in Australia and New Zealand, it’s smart to test the Splash’s battery annually from year three. Heat, short trips and infrequent use all speed up wear. A healthy, fully charged battery should read about 12.6 V at rest, anything around 12.3 V or less suggests it needs charging or testing. With the engine running, charging voltage should typically sit near 13.8–14.6 V.
When replacement time rolls around, match the original spec for capacity (Ah), cold cranking amps (CCA), case size, terminal layout and hold‑down style. If the Splash has factory stop/start, choose an EFB or AGM and have it coded/registered if required by the vehicle’s system. If it’s a conventional non‑stop/start model, a quality maintenance‑free flooded lead‑acid unit is usually appropriate.
- Common signs it’s due: slow cranking, dimming lights at idle, electrical glitches, swollen case, rotten‑egg smell, or repeated jump‑starts.
- Fitment tips: preserve memory with a saver if you can, clean and tighten terminals, avoid reversing polarity, reconnect any vent tube if applicable, and secure the hold‑down properly.
- Usage tips: do an occasional longer drive to top it up, keep terminals clean, and load‑test before winter or big trips.
- End of life: recycle the old unit responsibly at a battery recycler or parts store.
Most Splash batteries last about 3–5 years in local conditions, but city stop‑start driving and heat can shorten that. Proactive testing at service time helps avoid the hassle of a no‑start morning.
FAQs
What battery type does a 2011 Suzuki Splash use?
It uses a 12‑volt automotive starting battery. Non‑stop/start models usually take a maintenance‑free flooded battery. If the Splash has idle stop/start, use an EFB or AGM type to cope with frequent restarts. Capacity and CCA vary by engine and market, so check the owner’s manual or the label on the existing battery for exact specs.
How long should the battery last in Australia or New Zealand?
Typically 3–5 years. High heat, short trips, and long periods parked will reduce life. Testing the battery at each service, keeping terminals clean, and ensuring the alternator is charging correctly will help it go the distance.
Can they change the Splash battery themselves?
Yes, if they’re comfortable with basic tools and safety. Keep the car powered with a memory saver if possible, note radio/security presets, and never reverse polarity. On stop/start versions using EFB/AGM, some cars require battery registration, so a workshop visit can be the easier path.