Your Selected Vehicle
Parts for your 2011 Nissan Navara-Headlight bulbs
LED Autolamps Twin function side indicator with amber side marker - 97AIMCSB
LED Autolamps 12V Round Stop/Tail Lamp With Red Lens Recessed Mount - 102R
LED Autolamps Twin function rear position with supplementary rear indicator - 97CRIMB
Explore 4WD & Adventure
LED Autolamps Twin Function Stalk Side Indicator With Red/Amber Side Marker LHS Multivolt - 805ARIML
LED Autolamps Twin function rear position with supplementary rear indicator - 97RIMB
LED Autolamps Twin function side indicator with amber/red side marker - 97ARIM
LED Autolamps 12V Round Indicator Lamp With Amber Lens Recessed Mount 130mm Diameter - 102A
LED Autolamps Twin function front position with supplementary front indicator - 97CWIM
LED Autolamps Rear End Outline LED Marker Red 12/24v Red Lens 16cm Cable Blister Pack - 42RM
LED Autolamps Twin function front position with supplementary front indicator - 97WIMB
LED Autolamps 12/24V Reverse Light 200x50mm With 25 LEDs Black Bracket - 200BWM
LED Autolamps Twin function front position with supplementary front indicator - 97CWIMCSB
LED Autolamps Multi Volt Indicator Lamp With Clear Lens And Chrome Reflector Blister Pack - 131CAM
LED Autolamps Multi Volt Rear Combination LED Lamp With Grey Housing And Base - 275GARWMB
LED Autolamps 12/2V Maxilamp LED Stop/Tail/Indicator/Reflector Black Chrome Bolt Mount - MAXILAMPC1XCE
LED Autolamps 12V Stop/Tail/Indicator Lamp With Reflex Reflector 100x100x25mm - 100BAR
LED Autolamps 10/30V Chrome Series LED Red Amber Side Marker With 40cm Wire - 35CCARM
LED Autolamps Amber LED Indicator Lamp Insert For J3 Series Blister Pack - J3AM
LED Autolamps Twin function side indicator with amber/red side marker - 97CARIM
2011 Nissan Navara Headlight Bulbs
Headlight bulbs are absolutely fitted and relevant on the 2011 Nissan Navara (D40). Technical references such as the 2011 Navara Owner’s Manual and the D40 Service Manual (EXL – Exterior Lighting System) specify replaceable halogen headlight bulbs rather than sealed LED units. Many AU/NZ D40 models use separate low- and high-beam bulbs (commonly H11 low beam and HB3/9005 high beam), while some variants use a single H4 dual‑filament bulb. Always confirm the exact type against the owner’s manual, VIN-specific parts data, or the markings on the lamp housing.
On this ute, the headlight bulbs do what they’ve always done best: throw dependable light down the road for safe night driving and to keep the vehicle compliant with ADR/WOF requirements. Over time, halogen bulbs dim and shift yellow before they blow, so treating them as wear items is smart. The workshop advice is to replace in pairs to keep beam colour and brightness matched, and to check the aim after any bulb or housing work.
When it’s time for new bulbs, choose the correct base type and stick to road-legal wattage. High-wattage “off-road” bulbs can overheat wiring and melt reflectors. If the Navara sees lots of dusty or corrugated-road use, it’s worth carrying a spare set in the glovebox. During replacement, avoid touching the glass with bare fingers, inspect the connector for heat damage, and add a dab of dielectric grease on the terminals to fend off corrosion. If a new bulb still looks dim, check the earths, fuses, and the headlight relay, and clean the lens—cloudy plastic steals light output. Heavily oxidised lenses may need a proper restoration kit.
Enthusiasts sometimes ask about swapping to LED or HID. Unless the entire headlamp assembly is certified for those light sources, simple plug-in conversions generally aren’t road-legal under ADR and NZTA rules and may cause glare. For a legal brightness boost, consider premium halogen options that offer improved output within standard wattage.
- Replace in pairs, verify bulb type (H11/HB3 or H4) for the specific D40 variant.
- Don’t touch the glass, re-aim headlights after fitting.
- Keep wiring, connectors, and lenses clean and in good nick.
Popular questions about 2011 Nissan Navara headlight bulbs
What bulb type fits a 2011 Navara?
Many D40 models use H11 for low beam and HB3 (9005) for high beam, some trims use an H4 dual‑filament bulb. The safest check is the owner’s manual or the code on the back of the headlamp housing. If in doubt, a parts lookup by VIN will confirm it.
Can the halogen bulbs be upgraded to LED?
Plug-in LED retrofits in halogen housings are typically not road‑legal in Australia or New Zealand unless the headlamp assembly is approved for that light source. For legal on-road gains, choose premium halogen bulbs that stay within the standard wattage and meet ADR/NZTA requirements.
How often should the bulbs be replaced, and should both be done together?
There’s no fixed interval, but replace as soon as dimming or failure shows—most see 2–5 years depending on use. It’s best to replace both sides together so beam colour and brightness match, which improves night-time visibility and avoids uneven lighting.