Your Selected Vehicle
Parts for your 2011 Honda Stream-Headlights
Narva Dual Pole Battery Master / Isolation Switch Lever Type With Lockout (Contacts Rated 250A @ 12V) - 61066
Explore 4WD & Adventure
Narva Push Button Starter Switch On/Off Momentary SPST Blue LED (Contacts Rated 50A @ 12V) - 60097BL
Narva Sealed Rocker Switch Off/On SPDT 12V/24V Blue LED Illuminated Air Compressor Symbol (Contacts Rated 20A @ 12V) - 63228BL
Narva Sealed Rocker Switch Off/On SPDT 12V Blue Illuminated Compressor Symbol (Contacts Rated 20A @ 12V) - 63140BL
Narva 6 Way Rocker Switch Panel Off/On SPST Red LED With Fuse Protection (Contacts Rated 20A 12V) - 63193
Narva Sealed Rocker Switch Off/On 12V/24V Blue LED Illuminated Winch Power Symbol (Contacts Rated 20A @ 12V) - 63236BL
Narva Nissan Style Sealed Push Switch Off/On SPDT 12V Blue LED Illuminated Driving Lights Symbol (Contacts Rated 3A @ 12V) - 63376BL
Narva OE Style Sealed Push Switch Off/On SPDT 12V Blue LED Illuminated Beacon Symbol (Contacts Rated 3A 12V) - 63310BL
Drivetech 4x4 Rocker Roof Lights Switch On/Off SPST 12 or 24V Blue Illumination (Contacts Rated 20A @ 12V) - DT-11010
2011 Honda Stream Headlights: purpose, care, and when to replace
Based on Honda’s 2011 Stream owner’s manual and service information for RN6–RN9 models, plus lighting requirements under ECE and ADR rules, the 2011 Honda Stream is equipped with full front headlamps. So yes—headlights are absolutely relevant and used on this vehicle.
On the Stream, the headlights do the heavy lifting for safe night driving and low‑visibility conditions. Most trims run halogen bulbs (commonly H11 for low beam and HB3/9005 for high beam), while some market variants offered factory HID (D2S) with auto‑levelling and headlamp washers. Either way, they’re designed to throw a clean, well‑aimed beam without dazzling oncoming traffic, keeping everyone safer on Kiwi and Aussie roads.
As part of regular servicing, it’s smart to give the headlamps a quick once‑over. Check the lenses for UV haze or yellowing and make sure the beam aim hasn’t crept high or low. If there’s moisture inside the housing, the rear cap seal or vent may need attention. And if a bulb’s gone, replace in pairs so brightness and colour match across both sides.
- Bulb ID: Verify your exact trim—most 2011 Streams use H11 (low) and HB3/9005 (high), HID trims use D2S. Confirm by checking the lamp cap or VIN‑specific parts info.
- Fitting tips: Don’t touch the glass, use gloves. Seat the bulb fully and lock the retainer to avoid scatter or water ingress.
- Aim check: Park 3–5 m from a wall on level ground and compare cut‑offs left to right. Adjusters are on the lamp backs under the bonnet.
- Lenses: Light oxidation can be restored with a UV‑stable kit, heavy crazing may call for replacement housings.
- Upgrades: LED/HID retrofits into halogen housings can be illegal or fail WOF/rego if not compliant with ECE/ADR. Stick with compliant assemblies.
If the lights look dim, don’t assume the alternator’s crook—old halogens fade over time. Fresh, compliant bulbs and clean lenses often bring the Stream’s night vision back to form. During scheduled services, ask for a lighting check—beam aim, lens condition, wiring, connectors, and a quick voltage drop test—to keep everything bright and legal.
FAQs
What headlight bulbs fit a 2011 Honda Stream?
Most 2011 Stream variants use H11 for low beam and HB3/9005 for high beam. Some trims came with factory HID using D2S capsules. Always confirm by checking the markings on your lamp caps or your exact trim’s parts guide to avoid mix‑ups.
How often should the headlights be replaced or serviced?
Halogen bulbs can dim gradually after a few years or 400–600 hours. Many owners replace low beams in pairs every 2–4 years. At each service, inspect lens clarity, aim, and for any condensation. If visibility’s dropped or the lens is cloudy, address it before the next WOF/rego check.
Can I upgrade to LED or HID on my Stream?
Only if the upgrade is compliant. LED or HID kits in halogen reflectors often fail ADR/ECE/WOF standards. To stay legal, use bulbs the housing was designed for, or fit a compliant headlamp assembly engineered for LED/HID with proper beam control.