Skip to content Skip to navigation menu

Your Selected Vehicle

Brands

Part Location

Type

Price

Parts for your 2011 Honda Cr-v-Heater hose

Sort by
Showing 1 - 4 of 4 products

2011 Honda CR‑V heater hose — what it does and how to look after it

Yes, the 2011 Honda CR‑V does use heater hoses. Factory technical information confirms it: the Honda CR‑V 2007–2011 Service Manual (Cooling and HVAC sections) specifies disconnecting the heater hoses at the firewall when servicing the heater core, and Honda’s Electronic Parts Catalogue lists moulded “Heater Hose A” and “Heater Hose B” that run between the K24 engine and the heater core. Major aftermarket catalogues from Gates and Dayco also show application‑specific heater hoses for this model, reinforcing that they’re a standard, fitted component.

On this CR‑V, the heater hoses carry hot engine coolant through the firewall to the heater core and back again, letting the cabin heater work while also aiding temperature stability in the cooling system. They’re moulded EPDM rubber to clear engine bay hardware and are held on with spring clamps. If one fails, it can dump coolant quickly, so it’s worth giving them a look during regular servicing.

Good servicing practice for Aussie and Kiwi owners is simple:

  • Inspect at each service (or at least every 10,000–15,000 km): look for cracking, glazing, swelling, soft spots, or oil contamination, especially at the bends and clamp areas near the firewall.
  • Replace proactively at around 8–10 years or 160,000–200,000 km, or any time the hose feels spongy, is seeping, or shows surface crazing.
  • Use quality moulded hoses made for the 2011 CR‑V and retain the OEM‑style spring clamps or quality constant‑tension clamps to maintain even sealing as the hose expands and contracts.

When replacing, work on a cool engine. Depressurise the system by opening the radiator cap, catch the old coolant, then remove the two heater hoses at the firewall and engine side. Fit the new hoses in the same orientation, seat the clamps behind the factory witness marks, and refill with the correct Honda Type 2 long‑life coolant. Bleed by running the engine with the heater set to HOT, topping up as air purges