Parts for your 2010 Toyota Wish-Driveshafts

2010 Toyota Wish driveshafts: what they do and how to look after them

Driveshafts are absolutely relevant on the 2010 Toyota Wish. Toyota’s technical references for the ZGE20/ZGE25 series (Workshop/Repair Manual, Electronic Parts Catalogue and New Car Features) list left and right front drive shaft sub‑assemblies with constant‑velocity (CV) joints for all front‑wheel‑drive models, and additional propeller and rear drive shafts on 4WD variants. So whether it’s FWD or 4WD, the Wish uses driveshafts to get torque from the transaxle to the wheels.

On a 2010 Wish, the front driveshafts (often called CV axles) handle power delivery while allowing the suspension to move and the front wheels to steer. CV joints at each end keep things smooth through big steering angles and bumps. In typical Aussie and Kiwi use—school runs, motorway commutes and the odd gravel road—the shafts work quietly in the background, provided the rubber CV boots stay sealed and the grease inside stays clean.

Good servicing keeps them happy. At every service or roughly every 10,000–15,000 kilometres, have a quick look under the front and check the CV boots for cracks, splits or grease fling around the inner guards. Listen for clicking on full lock, vibration under load, or a shudder on take‑off—classic signs of CV wear. If a boot is torn but the joint hasn’t run dry, a boot kit and fresh high‑moly CV grease can save the day. If there’s pronounced clicking or play, a complete shaft is usually the smarter fix.

Tips specific to the Wish’s layout: if yours has the intermediate shaft and carrier bearing on the right‑hand side, check that bearing for play or rumble. When removing a shaft, replace the transaxle oil seal if it weeps and top up the CVT/ATF as specified. Always use new axle nuts, circlips and spindle washers, and torque everything to the factory spec. After refitting, recheck for leaks and road‑test for any vibration.

• Inspect boots at each service, more often if you drive on gravel or through coastal salt spray.
• Address grease leaks early—clean, re‑grease and reboot before the joint wears out.
• If a shaft is out, spin the hub and feel the wheel bearing, fix any play while you’re there.

Look after the driveshafts and the Wish will keep its trademark smooth, quiet drive for many trouble‑free kilometres.

Popular questions

Does the 2010 Toyota Wish have driveshafts, and are they the same as CV axles?
Yes. The Wish uses front driveshafts with CV joints on all models, and 4WD versions add a propeller shaft and rear drive shafts. “Driveshaft” and “CV axle” are commonly used interchangeably for the front half‑shafts.

How often should the CV boots be checked in Australia or New Zealand?
Have them inspected at each service or every 10,000–15,000 km. If you’re on gravel, in heavy rain, or near the coast, check more often because grit and salt age the rubber faster.

Is it OK to keep driving if a driveshaft is clicking?
It’s risky. A clicking CV joint can fail and leave you without drive, potentially damaging nearby components. Best move is to drive gently to a workshop and get it sorted.