Parts for your 2010 Toyota Camry-Driveshafts

2010 Toyota Camry Driveshafts

Driveshafts are fitted to the 2010 Toyota Camry. On this front‑wheel‑drive XV40 model, they’re the left and right front CV axle shafts that run from the transaxle to each front wheel. Technical sources such as Toyota’s 2010 Camry Repair Manual and the Toyota Electronic Parts Catalogue for AU/NZ list these front driveshafts/CV axles and show no rear propeller shaft, as there was no AWD or RWD variant offered locally. So while there’s no long tailshaft down the centre, the front driveshafts are absolutely relevant to this Camry.

The purpose of the driveshafts is simple but critical: they transfer engine torque to the front wheels while allowing for both suspension travel and steering angle. Each shaft uses constant‑velocity (CV) joints with flexible rubber boots packed with grease. When the boots stay sealed and the grease is clean, they’ll run quietly for ages. When a boot splits, the grease escapes and road grit gets in, which quickly wears the joint.

As part of regular servicing, it’s smart to inspect the CV boots for cracks, splits, or grease spray inside the wheel or along the control arms. Catching a torn boot early can save the joint. Typical warning signs that the driveshafts need attention include:

• Clicking or clacking on tight turns (outer CV joint wear)
• Shudder or vibration on acceleration (inner CV joint or shaft issues)
• Visible grease sling around the inner guard or on the chassis

Replacement options include new or quality remanufactured shafts. When replacing, use new axle nuts and cotter pins, and follow the factory torque specs. If the shaft has been pulled from the transaxle, expect a little fluid loss