Parts for your 2010 Suzuki Sx4-Tail lights

2010 Suzuki SX4 tail-lights: what they do and how to look after them

Tail-lights are absolutely fitted and relevant on the 2010 Suzuki SX4. That’s clear from technical sources including the 2010 Suzuki SX4 owner’s manual (which lists rear position/stop lamp bulbs), Australia’s ADR 13/00 (Installation of Lighting and Light-Signalling Devices), and New Zealand’s Land Transport Rule: Vehicle Lighting 2004. The SX4 carries conventional rear position lamps integrated into the tail-lamp assemblies, with red lenses and dual-intensity bulbs for running and braking—exactly what’s required for roadworthiness across AU and NZ.

On the road, the SX4’s tail-lights make the car visible from behind at night and in low light, and ramp up in brightness for braking. They’re a small part with a big safety job, helping the vehicle meet legal lighting standards and giving other drivers a clear read on distance and intent. Keeping them bright, the right colour, and evenly matched left-to-right is essential for a WOF/RWC and for everyday safety.

As part of regular servicing, a quick tail-light check is easy and worthwhile. Switch on the parkers and hazards, then press the brake—ideally with a helper or by reversing near a reflective surface. If a globe is out or dim, replace it promptly and consider doing both sides together so brightness matches. Always use the specified wattage and base style (the SX4 commonly uses a dual‑filament 21/5 W globe or W21/5W on some trims—check the owner’s manual or parts guide by VIN).

1. Open the tailgate and remove the rear lamp access panel.
2. Undo the lamp screws/bolts and pull the housing straight back to release the clips.
3. Twist the bulb holder anticlockwise, remove the old globe, and fit the correct new globe. Avoid touching the glass.
4. Inspect the foam/rubber gasket