Parts for your 2010 Suzuki Splash-Tail lights

2010 Suzuki Splash tail-lights

Tail-lights are absolutely relevant and factory-fitted on the 2010 Suzuki Splash. That’s both by design and by law: Australian Design Rules ADR 13/00 (Installation of Lighting) and ADR 49/00 (Rear and Front Position Lamps) require rear position lamps, and New Zealand’s Land Transport Rule: Vehicle Lighting 2004 does the same. Suzuki’s service and owner documentation for the Splash also lists a rear combination lamp assembly, confirming the part on this model.

On a 2010 Splash, the tail-lights sit in the rear combination assembly and provide steady red rear position lighting whenever the parkers or headlights are on. Their job is simple but critical: keep the car visible from behind at night, in rain, and at dawn or dusk, helping other road users judge distance and vehicle width. Good tail-light performance reduces rear-end risk and keeps the Splash compliant for rego or WOF checks.

Most 2010 Splash vehicles use conventional incandescent bulbs in the tail section, sometimes sharing a dual-filament bulb with the brake light depending on market. That means a bit of periodic TLC goes a long way. As part of routine servicing, it’s smart to check for blown bulbs, faded or cracked lenses, and any moisture inside the housing. A quick wipe to remove road film keeps the red colour bright and the light output consistent.

Replacement is usually straightforward. Access the lamp from the boot area, remove the trim panel, undo the retaining fasteners, then twist out the bulb holder. Fit the same type and wattage as specified in the handbook, avoid touching the glass with bare fingers, and re-seat the foam gasket so the housing stays watertight. After refitting, test parkers, brakes, and indicators before heading off.

• If both tail-lights are out, check the relevant fuse and the lighting switch first.
• If one side is dim, look for a poor earth or a corroded bulb holder.
• Persistent fogging usually points to a tired seal or a hairline crack—replace the gasket or the lens to fix it properly.
• LED retrofit bulbs are only suitable if they meet ADR/NZ requirements for colour and intensity