Parts for your 2010 Subaru Impreza-Oil seals

2010 Subaru Impreza oil-seals — what they do and when to replace them

Based on the Subaru Factory Service Manual for the 2010 Impreza, the Subaru Technical Information System, and the Subaru FAST electronic parts catalogue, oil seals are very much used and relevant on this model. The engine and driveline rely on several seals, including the front and rear crankshaft seals, camshaft seals, oil pump seal/O-ring, and transmission/differential axle and pinion seals.

On a 2010 Subaru Impreza (EJ-series engines), oil seals keep engine and gearbox oils where they’re meant to be. They sit around spinning shafts and housings to stop leaks under heat, pressure, and road grime. When they harden or wear, oil seeps past, leading to mess on the underbody, slipping belts, low oil levels, and that tell-tale burnt-oil whiff on warm days.

Smart servicing ties oil-seal checks to bigger jobs. During timing-belt service, it’s sensible to inspect the front crankshaft and camshaft seals. If there’s any wetness inside the timing cover, swap them out with quality (Viton) seals and a fresh oil pump O-ring. This is low extra labour while the front of the engine is open. Subaru guidance and workshop practice generally avoid preventative replacement of the rear main seal unless there’s actual leakage, as unnecessary removal can risk installation damage. If the gearbox is out and the bellhousing shows oil tracking, that’s the time to address it.

Keeping crankcase ventilation healthy helps seals last. A sticky PCV valve or blocked breather raises crankcase pressure and can push oil past otherwise decent seals. It’s a quick, inexpensive check that pays off.

For the driveline, axle and pinion seals on manual/auto transmissions and differentials should be inspected during fluid changes or when a CV shaft is removed. Any dampness around the seal lip or fling of oil on nearby components is a cue for replacement.

• Watch for: oil mist behind the crank pulley, timing cover wetness, oil on the crossmember or subframe, drips at the bellhousing, or diff oil weeping near axle stubs.
• Best practice: use OEM-quality seals, clean and lightly oil the sealing lip, verify shaft surfaces are smooth, press seals square, and torque everything to spec from the Subaru FSM.
• Typical timing: inspect every major service