Parts for your 2010 Nissan Serena-Tail lights

2010 Nissan Serena tail-lights

Tail-lights are absolutely relevant and fitted to the 2010 Nissan Serena. Technical sources such as the Nissan Serena C25/C26 Owner’s Manual and the Nissan Service Manual (Lighting System) specify rear combination lamps that include tail (rear position) lamps, stop, indicator, and reverse functions. AU and NZ road standards that adopt UN ECE lighting rules (for example, the requirements equivalent to ECE R7 for rear position lamps) and local WOF/roadworthy criteria also mandate working red tail-lights, which confirms their use on this model.

On the 2010 Serena, the tail-lights sit within the rear combination assemblies and keep the vehicle visible from behind at night and in poor weather. They differ from brake lights: tail-lights glow steadily whenever the park/headlights are on, while the brake filament brightens only when the pedal’s pressed. Most 2010 Serena variants use incandescent globes (commonly a dual‑filament 21/5W for stop/tail), though some trims can feature LED elements for the tail (running) function. Always confirm globe type in the owner’s manual or by checking the existing unit.

Good servicing habits go a long way. Inspect lenses for cracks, fading, or moisture, a foggy lens knocks down brightness and can lead to a WOF or roadworthy fail. Check wiring and earths if the lamps look dim or flicker. If a globe keeps blowing, look for water ingress, poor connections, or the wrong wattage globe. For LED-equipped tails, the light is usually a sealed unit—if it fails, the full lamp assembly may need replacement.

• Common signs they need attention: dim/red going brownish, intermittent operation over bumps, moisture inside the lens, or one side noticeably darker.

1. Open the tailgate and remove the two retaining screws/fasteners for the rear lamp (they’re on the inner edge).
2. Gently pull the lamp rearwards to release the locating pins.
3. Twist the bulb holder anticlockwise, swap the globe for the same base and wattage (e.g., P21/5W for stop/tail), and avoid touching the glass with bare fingers.
4. Refit, test park and brake lights, and reinstall the screws snugly—don’t overtighten.

• Service tips: keep contacts clean and use a dab of dielectric grease, replace any perished lamp gaskets to stop condensation, and clean the lens with mild car shampoo only. Carry a spare set of globes if you’re doing regular night driving.

Popular questions about 2010 Nissan Serena tail-lights

What globe fits the 2010 Serena tail-light?
Most use a dual‑filament 21/5W (P21/5W) for the stop/tail function and T10 wedges for licence-plate lights. Some trims may use LED tail (running) elements within the cluster. Always match the base and wattage stamped on the old globe or confirm via the owner’s manual/VIN label.

If your Serena has LED tails, the running-light portion isn’t a serviceable globe—replacement is the full lamp assembly.

Why is there condensation in my Serena’s tail-light?
Moisture usually means a compromised seal, cracked lens, or a missing grommet. Light mist that clears after driving can be normal, but visible droplets or pooling will dull the output and can corrode terminals.

Remove the lamp, dry it out, replace the gasket or sealant as required, and check for housing cracks. Avoid over‑wattage globes that overheat and warp the plastic.

Will a failed tail-light fail WOF/roadworthy in AU/NZ?
Yes. Road rules require functioning red tail (rear position) lamps whenever the lights are on. A blown globe or inoperative tail will typically attract a fail until fixed.

It’s safe practice to get it sorted promptly. If you must travel, do so in daylight and repair or replace the lamp before night driving.