Parts for your 2010 Honda Stream-Brake shoes

2010 Honda Stream brake shoes — are they used?

Short answer: brake shoes aren’t used on the 2010 Honda Stream (RN6–RN9). The model runs rear disc brakes with a floating caliper, and the handbrake acts directly on that caliper rather than on a separate drum-and-shoe setup. This layout is detailed in the Honda Stream second‑generation service manual (Brakes section: Rear Disc Brake and Parking Brake subsections), and it’s reflected in Honda’s Electronic Parts Catalogue (EPC) for RN6–RN9, which lists rear calipers, pads and rotors, but no rear brake shoes. Major AU/NZ aftermarket catalogues also list rear pads and rotors for 2010 Stream, with no shoe part numbers, backing up the factory documentation.

Why no brake shoes? Honda engineered the second‑gen Stream with four‑wheel disc brakes for stronger, more consistent braking under heat and load, and to sharpen pedal feel. Instead of a drum-in-hat parking brake with shoes, the Stream’s cable-operated handbrake links to a lever on the rear caliper, clamping the disc mechanically when the lever is pulled. It simplifies parts, trims unsprung weight, and makes servicing more straightforward.

What does that mean for owners and workshops? When the rear brakes need attention, they’ll be dealing with pads, rotors, calipers and the handbrake cable—there are no rear brake shoes to replace. Best practice during a service includes:

• Inspecting rear pads for even wear and replacing them before they hit minimum thickness.
• Measuring rotor thickness and runout, machining only if within spec, otherwise replacing.
• Cleaning and lubricating caliper slide pins with high-temp brake grease to prevent binding.
• Checking the caliper’s handbrake lever returns freely, freeing off or rebuilding sticky mechanisms.
• Adjusting and lubricating the handbrake cables, and confirming the lever travel is within spec.
• Flushing brake fluid every two years or 40,000 km to keep the hydraulic system healthy.

If a parts listing shows “brake shoes” for a 2010 Stream, it’s almost certainly a catalogue error or a mix‑up with earlier generations or other Honda models that used rear drums or drum-in-hat parking brakes. For this vehicle, the correct rear friction parts are pads and rotors.

• Does a 2010 Honda Stream have brake shoes?
  No. It uses rear disc brakes with pads and a caliper-integrated parking brake, so there are no rear shoes on this model.
• How does the handbrake work on a 2010 Honda Stream?
  A cable pulls a lever on each rear caliper, mechanically clamping the pads onto the rotor. There’s no separate drum or shoe inside the rotor.
• What should be replaced during a rear brake service on a 2010 Stream?
  Typically pads and, when worn, rotors. Also service the caliper slide pins, check the caliper parking-brake lever action, adjust the handbrake cables, and replace brake fluid on schedule.