Parts for your 2009 Honda Accord-Pedal pads

2009 Honda Accord Pedal Pads

Pedal pads are absolutely used on the 2009 Honda Accord. Honda’s 2008–2012 Accord Service Manual (Brake and Clutch Controls sections) illustrates rubber-faced pads on the brake pedal (all models) and the clutch pedal (manual models), and the Honda Electronic Parts Catalogue lists both the surface pedal rubbers and a small brake pedal “stop” pad used for the brake-light switch. The Owner’s Manual also cautions against using cleaners or dressings that could make pedal surfaces slippery—another nod to the presence and importance of these pads.

On this Accord, pedal pads serve a simple but vital job: grip, comfort, and control. The textured rubber on the brake and clutch pedals helps shoes bite, especially in wet weather, reducing the chance of a slip at the worst moment. They also damp vibration and feel more comfortable on long drives. Beyond the big visible pads, there’s a small rubber stop pad on the brake pedal arm that the switch presses against, when it degrades or falls out, the brake lights may stay on and the battery can go flat. The accelerator is typically a one-piece pedal without a separate rubber pad.

As part of routine servicing, it’s smart to inspect the pedal pads every visit or around 10,000–15,000 km. Look for glazing, hardening, cracking, or a worn-smooth surface. If the pattern’s gone shiny or there’s less bite underfoot, it’s time to replace. For manuals, check the clutch pad the same way. For the brake stop pad, confirm the brake lights switch off promptly when the pedal’s released.

Replacement is quick and inexpensive. The surface pads usually slip off and press on by hand, a dab of mild soapy water can help seat a tight new pad. The tiny stop pad pushes into a hole on the pedal arm—once fitted, always test the brake lights, cruise control, and shift interlock (auto) to make sure everything behaves. Clean pedal rubbers with mild soap and water only, avoid silicone sprays or protectants that leave them slick. Quality genuine or reputable aftermarket pads fit snugly and keep the Accord compliant with local safety expectations in Australia and New Zealand.

• Replace if the pad is shiny, cracked, or slippery.
• Check the brake stop pad if brake lights stay on or the battery keeps draining.
• Ensure floor mats are anchored and don’t foul the pedals.

Do all 2009 Accords have pedal pads?
Yes. Every 2009 Accord has a rubber brake pedal pad and the small brake pedal stop pad. Manual-transmission cars also have a clutch pedal pad. The accelerator is generally an integrated pedal without a separate rubber pad, so there’s nothing to replace there.

How long does replacement take and what might it cost?
Most workshops can swap a surface brake or clutch pedal pad in a few minutes, and the small brake stop pad in about the same time. Parts are typically affordable—often a few tens of dollars per pad in AU/NZ—so it’s a quick, low-cost safety win during a service.

Can universal pedal covers be used?
It’s best to stick with genuine or vehicle-specific pads. Oversized alloy covers or loose universal rubbers can reduce clearance or slip, which could be frowned upon at a WoF/roadworthy. Properly fitting pads ensure safe pedal feel and compliance.