Parts for your 2009 Ford Fiesta-Suspension bushes

2009 Ford Fiesta suspension bushes — what they do and when to replace them

Technical sources including the Ford Workshop Manual (Section 204-01 Front Suspension and 204-02 Rear Suspension) and the Haynes Ford Fiesta (2008–2017) service manual confirm that the 2009 Ford Fiesta is fitted with multiple suspension bushes. These include the front lower control arm bushes, anti-roll bar (stabiliser) bushes, and rear torsion-beam pivot bushes. Parts catalogues used by workshops list these bushes as routine service and replacement items, so they’re absolutely relevant on this model.

On a 2009 Fiesta, suspension bushes act as the flexible mounts that isolate noise and vibration while keeping alignment steady under braking and cornering. They’re pressed into arms and brackets, allowing a bit of controlled movement without metal-on-metal contact. When they wear or tear, drivers often notice a clunk over bumps, vague steering, or uneven tyre wear. Left too long, worn bushes can chew out tyres and make the car tramline or wander on the motorway.

As part of servicing, it’s smart to inspect all bushes every 10,000–15,000 km or annually. Look for cracks, perishing, and split voids, especially in the front lower arm rear bushes and the rear beam bushes. If there’s excessive movement with a pry bar, or if the anti-roll bar bushes are allowing the bar to knock, it’s time to replace.

Replacement tips workshops follow:

• Torque all arm and beam pivot bolts at normal ride height (wheels supporting the car) to avoid preloading the rubber.
• Replace single-use fasteners where specified by the workshop manual.
• Press-in bushes must be oriented correctly