Skip to content Skip to navigation menu

Your Selected Vehicle

Brands

Price

Parts for your 2008 Toyota Mark x-Suspension bushes

Sort by
Showing 1 - 2 of 2 products

2008 Toyota Mark X suspension bushes — what they do and when to replace them

Suspension bushes are absolutely used on the 2008 Toyota Mark X (X120 series). Technical sources including the Toyota Electronic Parts Catalogue for the X120 Mark X (2004–2009) and the Toyota repair manual for its front double-wishbone and rear multi‑link suspension layouts show multiple bushings fitted: front lower and upper control arm bushes, rear multi‑link arm bushes, subframe and differential mounting bushes, and stabiliser (sway) bar D‑bushes and link bushes. That makes “suspension bushes” directly relevant to this model’s suspension service and parts replacement.

On a Mark X, bushes are the quiet achievers. These rubber or elastomer sleeves isolate vibration, soak up harshness, and let the arms and links pivot in a controlled way so the wheels keep their alignment angles where they should be. Healthy bushes keep steering feel tight, braking stable and tyre wear even. As they age, the rubber hardens, cracks or tears, allowing unwanted movement that shows up as clunks over bumps, vague steering, shimmy under braking and feathered or uneven tyres.

Common wear points on the 2008 Mark X include front lower control arm bushes, rear lateral and trailing arm bushes, and the stabiliser bar D‑bushes. Oil contamination from engine or diff leaks can speed up deterioration, and the age of these cars now means many original bushes are past their best even if kilometres are modest.

  • Tell‑tale signs: knocking noises on rough roads, steering wander, mid‑corner instability, brake shudder that isn’t rotor‑related, and rapid or uneven tyre wear.
  • Inspection tips: look for perishing, cracks, split bonds and excessive free play with a pry‑bar. Check during routine services every 20,000–30,000 km, especially if the vehicle sees rough roads.

When replacing bushes on a Mark X, it’s smart to do them in axle pairs (both sides) to keep handling balanced. Press‑fit bushes need the right tools and orientation marks lined up