Your Selected Vehicle
Parts for your 2008 Toyota Land cruiser-Temperature sensors
Explore 4WD & Adventure
2008 Toyota Land Cruiser temperature-sensors: what they do and how to look after them
Temperature-sensors are absolutely fitted to the 2008 Toyota Land Cruiser (J200 series). Technical sources including the Toyota Land Cruiser 200 Series Repair Manual (Engine Control System sections for 1VD-FTV/1UR-FE/3UR-FE), the 2008 Land Cruiser Electrical Wiring Diagram (EWD), and OBD-II standards (SAE J1979) all show multiple temperature inputs: Engine Coolant Temperature (ECT), Intake Air Temperature (IAT), Ambient Air Temperature, Automatic Transmission Fluid (ATF) temperature, and HVAC-related sensors. These are used by the engine ECU, transmission control, and climate system to manage fuelling, ignition, shifting, cooling-fan strategy, and cabin comfort.
On a 2008 Land Cruiser, the ECT sensor is the big one. It tells the ECU how hot the engine is so it can adjust cold-start enrichment, idle speed, fan operation, and even enable closed-loop control. The IAT helps fine‑tune spark and fuelling as intake temps change, while the ATF temp sensor protects the auto by modifying shift timing and torque‑converter lock‑up under load or heat. Outside temp and evaporator sensors keep the air‑con behaving on scorching Aussie and Kiwi days.
They’re not a routine “change by kilometres” item, but they do age. A crook sensor or crusty connector can cause hard starts, rich running, poor economy, thermo fans stuck on, harsh shifts, or DTCs like P0115–P0119 and P0125. Typical checks during servicing are quick and worthwhile:
- Scan-tool live data: confirm ECT rises smoothly from ambient to normal operating temp.
- Visuals: inspect connectors and wiring under the bonnet for corrosion, oil wicking, or chafe.
- Cooling system health: correct coolant mix and no air pockets (air can fool an ECT reading).
When replacement is needed, it’s a straightforward job if approached carefully:
- Allow the engine to cool fully and depressurise the cooling system.
- Disconnect the battery if working near the loom
