Skip to content Skip to navigation menu

Your Selected Vehicle

CATEGORIES

Brands

Show More Show Less

Price

Parts for your 2008 Toyota Land cruiser-Batteries

Sort by

Explore 4WD & Adventure

Stedi Quad Pro LED Driving Lights - LEDQUAD-PRO

Stedi Quad Pro LED Driving Lights - LEDQUAD-PRO

$759
Fitment Notes:
See More
Stedi EVO 22 inch LED Light Bar - ST-02-EVO-022

Stedi EVO 22 inch LED Light Bar - ST-02-EVO-022

$1,149
Fitment Notes:
See More
Hella Black Magic 6.2 inch LED Light Bar - 1FB358176201

Hella Black Magic 6.2 inch LED Light Bar - 1FB358176201

$107
Fitment Notes:
See More
Hella Black Magic 6.2 inch LED Light Bar - 1FB358176211

Hella Black Magic 6.2 inch LED Light Bar - 1FB358176211

$144
Fitment Notes:
See More
Narva EX2-R 20 inch LED Light Bar - RGB Enabled - 72839

Narva EX2-R 20 inch LED Light Bar - RGB Enabled - 72839

$541
Fitment Notes:
See More
Narva EX2 10 inch LED Number Plate Light Bar - 72833

Narva EX2 10 inch LED Number Plate Light Bar - 72833

$262
Fitment Notes:
See More
Light Bar 300W 811mm Double Row 27000 Lumen - 72773

Light Bar 300W 811mm Double Row 27000 Lumen - 72773

$4,788
Fitment Notes:
See More
Showing 1 - 39 of 74 products

2008 Toyota Land Cruiser batteries: what they do and how to look after them

Per Toyota’s technical documentation for the J200 (2008 200 Series) — including the Owner’s Manual and service literature — the vehicle is designed to run a 12‑volt lead‑acid starting battery. Many diesel variants (e.g., VDJ200) are factory‑equipped with dual starting batteries, while petrol models commonly use a single unit. So yes, batteries are absolutely relevant and fitted on a 2008 Toyota Land Cruiser.

The batteries power the starter motor, engine management, fuel system, and all the electronics that keep the Cruiser civilised on and off the track. They also stabilise system voltage, back up the alternator at idle, and keep alarms, locks, and memory settings alive when parked.

As part of routine servicing, it’s smart to test the battery state of health annually. A healthy resting voltage is around 12.6 V, 12.2 V is getting marginal, under 12.0 V is effectively flat. With the engine running, alternator output should typically sit about 13.8–14.4 V. If your Cruiser has dual start batteries, treat them as a pair — replace both together to avoid imbalance.

Replacement timing depends on use and climate, but three to five years is typical. Tell‑tales include slow cranking, dim lights at idle, intermittent warning lamps, swollen cases, or corrosion around posts. Touring rigs with fridges, winches, or light bars may benefit from high‑CCA or AGM options, follow Toyota’s spec and match or exceed the original cold‑cranking amps and capacity. Check terminal layout and physical size so it lands in the tray without twisting the leads.

When fitting, isolate power, keep polarity correct, and secure the hold‑down firmly — corrugations can shake a loose battery to bits. Clean terminals, neutralise any acid residue, and use a light protective spray on clamps. If the vehicle sits for long periods, a smart maintainer will prevent sulfation. After replacement, some features (like auto up/down windows) may need a quick re‑initialisation per the Owner’s Manual.

  • Service checklist: test voltage and CCA, inspect clamps, tray, and earths, verify alternator charge, top up fluid only if it’s a serviceable flooded type, recycle old batteries responsibly.
  • Diesel note: dual batteries are common on 2008 V8 diesels — keep brands, age, and specs matched.
  • Accessory loads: consider AGM/deep‑cycle for auxiliary systems via a proper dual‑battery setup and isolator.

FAQs

Does the 2008 Land Cruiser have dual batteries from factory?

Many 2008 VDJ200 diesel models in Australia and New Zealand are factory‑fitted with dual 12‑volt starting batteries. Petrol variants typically have a single starting battery, though some owners add a second auxiliary battery for touring. A quick look under the bonnet will confirm your setup.

What battery type should be used?

Follow the Owner’s Manual specifications for physical size, terminal layout, and minimum CCA. For heavy accessory loads or winching, a high‑quality flooded maintenance‑free or AGM starting battery is a popular choice. If running a dedicated auxiliary for fridges and camping gear, use a suitable deep‑cycle/AGM with an isolator.

How often should batteries be replaced?

Expect around three to five years in typical conditions. Replace sooner if cranking slows, voltage sags, or test results show low CCA. For dual systems on diesel models, replace both start batteries together to keep them balanced and reliable.