Your Selected Vehicle
Parts for your 2008 Suzuki Splash-Headlights
Penrite Vantage Semi Synthetic 5W-30 Engine Oil 6L - VANSEMI5W30006
Penrite Enviro+ Full Synthetic 0W-20 Engine Oil 5L - EPLUS0W20005
Explore 4WD & Adventure
Penrite Enviro+ Full Synthetic 5W-20 Engine Oil 20L Enviro Box - EPLUS5W20020BOX
Penrite Enviro+ Full Synthetic 0W-20 Engine Oil 10L Enviro Box - EPLUS0W20010BOX
Penrite Enviro+ Full Synthetic 5W-20 Engine Oil 10L Enviro Box - EPLUS5W20010BOX
Castrol Transmax Multi-vehicle Dex/Merc Automatic Transmission Fluid 1L - 3428484
Castrol Transmax ATF Dex/Merc LV Multi-Vehicle Automatic Transmission Fluid 20L - 3430696
Penrite Vantage MV Full Synthetic 5W-30 Engine Oil 20L - VANMV5W30020
Castrol Transmax ATF Dex/Merc Multi-vehicle Automatic Transmission Fluid 20L - 3429062
Penrite Enviro+ GF-S 5W-30 Engine Oil 20L Enviro Box - EPLUSGF5020BOX
Penrite Enviro+ Full Synthetic 0W-20 Engine Oil 20L - EPLUS0W20020
Castrol Transmax Multi-vehicle Dex/Merc Automatic Transmission Fluid 4L - 3428483
Penrite ATF FS Multi-Vehicle Automatic Transmission Fluid 4L - ATFFS004
2008 Suzuki Splash headlights — what they do and how to look after them
Headlights are absolutely fitted to the 2008 Suzuki Splash. That’s confirmed by the model’s owner’s manual and the lighting standards the car was built to meet (ECE R48 in Europe and equivalent ADR lighting rules for local compliance). From factory, the Splash uses conventional halogen headlamps and features low and high beam for safe night driving and daytime visibility.
On this little hatch, the headlights pull more than night duty. They help others spot the car at dawn, dusk, in rain, and through winter gloom. Clear, well-aimed beams reduce eye strain and sharpen road-edge contrast, which is priceless on country roads and during long Kiwi and Aussie kilometres. If bulbs are ageing or the lenses are cloudy, output drops noticeably, so it’s smart to treat headlights as a service item rather than a “fix it when it fails” job.
- Inspect at every service (or 10,000 km): look for dull light, cracked lenses, moisture, and burnt connectors.
- Replace bulbs in pairs to keep beam colour and brightness even left to right.
- Avoid touching the glass of new halogen bulbs, skin oils create hot spots and shorten life.
- Keep lenses clean with car-safe plastic cleaners, avoid harsh solvents that can haze polycarbonate.
- Check aim after any front-end work or if the car’s heavily loaded, mis-aimed lamps can dazzle or under-illuminate.
DIY bulb swap is straightforward. Park safely, switch off, pop the bonnet, and reach the back of the headlamp. Remove the dust cap, unplug the connector, unclip the spring retainer, and ease out the old bulb. Fit the new bulb the same way round, clip it in, reconnect, refit the cap, and test both beams. Not sure on the exact bulb spec? The owner’s manual and the marking on the lamp housing will list it (many Splashes use halogen types commonly noted as H4 or H7—confirm before buying).
If lenses are yellowed, a quality restoration kit can revive clarity. Persistent fogging or water inside usually points to a failing seal or cracked housing—worth sorting promptly to protect the reflector and wiring. A quick headlight check during routine servicing keeps the Splash safe, legal, and comfy to drive after dark.
What bulb type fits a 2008 Suzuki Splash headlight?
Most markets see the Splash running halogen bulbs, commonly H4 (dual-filament) or a combination like H7/H1 depending on trim and headlamp design. The definitive answer is in the owner’s manual or on the headlamp label. It’s smart to read the marking before buying, then replace bulbs in pairs for an even beam.
How do you adjust headlight aim on a 2008 Suzuki Splash?
Use the vertical and horizontal adjusters on the back of each headlamp. Park 3–5 metres from a wall on level ground, set normal tyre pressures and vehicle load, and adjust to achieve a clean cut-off that sits at the correct height without dazzling. If unsure, ask a workshop to set aim during a service or safety inspection/WOF.
Why are the headlights cloudy, and can they be restored?
UV exposure oxidises the plastic, causing yellowing and haze that cuts light output. A quality restoration kit can remove oxidation and add a protective layer. If the inside is dull, or the lens is cracked and letting moisture in, replacement of the assembly is often the better long-term fix.