Your Selected Vehicle
Parts for your 2008 Subaru Exiga-Headlights
LED Autolamps 12V Black Chrome Round Indicator Lamp With Clear Lens - 102ABC
LED Autolamps 355 Series Multi Volt Black Stop/Tail/Indicator/Reverse/Reflector LHS & RHS Twin Blister Pack - 355BARWM-2
LED Autolamps 12V Sequential Indicator Strip Light 10 Square LEDS Amber Lens Blister Pack - 235ASEQ-2
LED Autolamps 12/24V 280 Mini Jumbo Stop/Tail/Indicator Lamp Blister Pack - 280ARRM
Explore 4WD & Adventure
LED Autolamps Twin function side indicator with amber side marker - 97CAIMCSB
LED Autolamps 385 Series Rear Combination Lamp LHS with 7 core plug - 385ARWMLCSB
LED Autolamps 12V Stop/Tail/Ind/Rev LED Light Kit 450mm Loom DT04 Connector - SO282ARWM2LR450
LED Autolamps 12V Sequential Indicator Strip Light 10 Square LEDS Amber Lens Bulk Packaging - 235ASEQB
LED Autolamps 12/24V LED Stop/Tail/Indicator/Reflector Light 28cm Cable Blister Pack - 275MAR
LED Autolamps Multi Volt Round Indicator Lamp With Amber Lens Recessed Mount - 102AM
LED Autolamps 12/24V Stop/Tail/Indicator/Reflector With Licence Plate Lamp - 99ARLM
LED Autolamps 12V Front Indicator/Marker Lamp 80mm Round Blister Pack - 80AW
LED Autolamps 174 Series Rear Indicator Lamp 12/24V, Surface Mount, 40cm Cable - 174AMB
LED Autolamps 12/24V LED Stop/Tail/Indicator Lamp With Reflex Reflector Blister Pack 1 pce - 150ARM
LED Autolamps 10/30V LED Side Direction Indicator Light With 3m Tinned Cable - 58AM3
LED Autolamps 12/24V Stop/Tail/Indicator/Reverse Lamp With Inbuild Reflectors - 283ARWM
LED Autolamps 12V LED Stop/Tail/Indicator Assembly Light With Black Bracket - 80BAR
OEX Black Nylon Cable Ties - 4.8mm x 200mm, with Mounting Hole - 100 Pc - ACX1318
LED Autolamps Multi Volt Reverse Lamp With 35 SMDS Blister Pack With Black Base - 135WM
LED Autolamps Multi Volt Stop/Tail/Indicator Assembly 72 LEDs With Black Bracket - 200BARM
LED Autolamps 12V LED Stop/Tail/Indicator Light With Reflex Reflector Twin Blister - 100BAR2
2008 Subaru Exiga Headlights: Purpose, Care, and When to Replace
Headlights are absolutely fitted to the 2008 Subaru Exiga. This is confirmed by Subaru’s 2008 Exiga (YA series) owner and service literature, and required by road standards such as Australian Design Rules for lighting (e.g., ADR 13/00 and 46) and New Zealand’s WOF/VIRM lighting requirements. So yes—headlights are relevant, essential, and legally mandatory on the 2008 Subaru Exiga.
On this seven-seat wagon, the headlights do the heavy lifting after dark: they light the road, make the Exiga visible to others, and support safe driving in rain or foggy coastal mornings. Most 2008 Exiga trims use halogen reflector units (commonly H11 low beam and HB3/9005 high beam), while some higher-spec variants may run factory HID/xenon projectors with auto-levelling. Beam patterns are RHD for Australia and New Zealand roads, so it’s important to fit lights designed for local traffic direction.
As part of regular servicing, it’s smart to treat the headlights like any other safety-critical item. Halogen bulbs gradually dim with age, replacing them in pairs keeps light colour and brightness even. If the car has HID, remember they run high voltage—best left to a qualified tech—and bulbs and ballasts are typically replaced as matched components.
- Check brightness and aim every 12 months, or sooner after a bulb change or front-end work.
- Inspect lenses for UV haze, a quality restoration kit can bring clarity back and improve output.
- Look for moisture inside the housing—mild mist can be normal, but persistent water means a cracked seal or vent issue.
- Avoid touching bulb glass, use gloves and keep connectors clean with a dab of dielectric grease.
- After any swap, verify the beam cut-off and height to ADR/NZTA specs to avoid glare.
DIY bulb swaps on halogen-equipped Exigas are generally straightforward: disconnect the battery negative, access the rear cap, twist out the bulb, and refit the correct type. If unsure of the exact bulb spec, check the owner’s manual or the label behind the dust cap—trim and market variations exist. When lenses are extensively crazed or mounting tabs are cracked, a full headlight assembly replacement is the safest fix, and it’s a good chance to refresh both sides for consistent performance.
Popular questions about 2008 Subaru Exiga headlights
What bulb types fit a 2008 Subaru Exiga?
Most halogen models commonly use H11 for low beam and HB3/9005 for high beam, while some trims have HID/xenon projectors. Always confirm against the vehicle’s manual or the markings on the lamp housing as market and trim can differ.
How often should headlight bulbs be replaced?
There’s no fixed kilometre count, but halogens can lose noticeable brightness in 2–3 years. Replace in pairs when output drops, one fails, or if the light colour no longer matches. HID capsules typically last longer but should also be replaced in pairs.
Why is there condensation in my Exiga’s headlight?
Light fogging after wet weather can be normal and may clear after a drive. Visible water pooling or persistent mist points to a leak or blocked vent, inspect seals and caps, and repair or replace the housing to protect electrics and maintain beam quality.