Parts for your 2008 Nissan Dualis-Wheel hubs

2008 Nissan Dualis Wheel Hubs

Wheel hubs are absolutely used on the 2008 Nissan Dualis (J10). Technical references include the Nissan Factory Service Manual (J10), notably sections FAX (Front Axle) and RAX (Rear Axle), which detail the hub-and-bearing assemblies and their fastening to the steering knuckle and rear axle carrier. Genuine parts catalogues for the J10 platform also list complete front and rear hub units with integrated ABS encoder rings and wheel studs, confirming fitment on both 2WD and AWD variants.

On the Dualis, the wheel hub’s job is to hold the wheel true, spin smoothly on its sealed bearing, and provide the mounting for the brake rotor and wheel studs. Modern hub units for this model are a sealed, bolt-on assembly. They support the vehicle’s weight, keep rolling resistance low, and ensure accurate ABS signals thanks to their built-in encoder ring. If a hub’s bearing wears, owners will often notice a humming or growling that changes with road speed, slight steering vibration, or an ABS warning light.

Servicing is straightforward: these hubs are maintenance-free units, so there’s no periodic greasing. Instead, they’re inspected at service time for free play, roughness when rotated, heat discolouration around the hub, uneven tyre wear, and any ABS faults. When replacement is needed, the assembly is swapped out as a complete unit. Front hubs are bolted to the knuckle from the rear, and the driveshaft passes through the hub