Parts for your 2008 Honda Elysion-Tail lights

2008 Honda Elysion tail-lights: what they do and how to look after them

Tail-lights are absolutely fitted to the 2008 Honda Elysion. This is confirmed by the Honda Elysion Owner’s Manual (2008, Lights section) and Honda’s Electronic Parts Catalogue, which both list a rear combination lamp assembly. Requirements under ADR 13/00 (installation of lighting), UNECE R48, and New Zealand’s Land Transport Rule: Vehicle Lighting 2004 also mandate rear position lamps on passenger vehicles, so tail-lights are very much relevant on any roadgoing Elysion, including grey imports.

On the Elysion, the rear combination lamp houses the tail (rear position) lamps, brake lamps, indicators, and reverse lights. The tail-lights keep the van visible from behind at night and in foul weather, while the brighter brake lamps warn following drivers when it’s slowing. Most 2008 models use incandescent bulbs for tail and stop functions, with some variants featuring LED elements in the assembly.

As part of regular servicing, it’s smart to give the tail-lights a once-over. Check operation with the park lights on, press the brake pedal (or have a mate help), and verify indicators and reverse lights. Clean the lenses with a mild car wash solution—no harsh solvents—and inspect the seals for cracks or gaps that can let moisture in. If there’s fogging or water droplets inside, address it quickly to avoid corroded bulb holders and dodgy earths.

If a bulb’s out, confirm the fuse first, then access the lamp from the tailgate side. Remove the trim clips, undo the mounting screws, disconnect the harness, and twist out the bulb holders. Replace like-for-like bulbs—avoid mixing wattages—and test before refitting. For assemblies with LED modules, the fix is usually to replace the whole unit, as LEDs aren’t serviceable individually.

• When to replace: cracked or cloudy lenses, persistent condensation, intermittent lighting, or collision damage.
• Service tip: inspect lighting every 6 months or at each oil change, keep spare bulbs in the glovebox for road trips.
• Compliance note: for AU/NZ, ensure correct colours (red tail/stop, amber indicators) and brightness, avoid dark tints that can fail roadworthy checks.

Done right, a quick tail-light check keeps the Elysion safe, legal, and easy to see—especially on those wet winter evenings.

Popular questions about 2008 Honda Elysion tail-lights

What bulb types does the 2008 Elysion use for the tail-lights?

Most 2008 Elysion models use wedge-base incandescent bulbs, commonly 7443 (dual-filament stop/tail) and T10 for position lamps, though trims and market variants can differ. The owner’s manual or the marking on the old bulb is the best guide. If the assembly has LED modules, the unit is typically non-serviceable and replaced as a whole.

How can condensation in the tail-light be fixed?

Minor misting after rain can be normal and may clear with a warm drive. Persistent moisture points to a leaking seal or cracked housing. Remove the assembly, dry it gently, renew the gasket or sealant, and replace any damaged vents or caps. If the lens is cracked, fit a new lamp to avoid ongoing water ingress.

Are aftermarket LED tail-lights legal in Australia and New Zealand?

They can be, provided they meet ADR/UNECE rules: correct colour, brightness, visibility angles, and proper operation with the vehicle’s electrics. Look for compliant markings and avoid overly tinted designs. If unsure, get advice from a roadworthy inspector or compliance specialist.