Parts for your 2008 Honda Cr-v-Pedal pads

2008 Honda CR‑V pedal pads: what they do and when to replace them

Pedal pads are absolutely relevant to the 2008 Honda CR‑V. Honda’s factory service information for the 2007–2011 CR‑V platform calls for inspecting the brake pedal pad for wear during routine servicing, and the Honda electronic parts catalogue lists a replaceable rubber pad for the brake pedal (and for the clutch pedal on manual models). The accelerator pedal on these vehicles is a hard plastic assembly and doesn’t use a separate rubber pad.

On a 2008 Honda CR‑V, the pedal pads are the grippy rubber covers that sit on the metal pedal faces. They’re there to give the driver solid traction underfoot, especially in the wet, and to keep pedal feel consistent day in, day out. Automatics run a single brake pedal pad, manuals have both brake and clutch pedal pads. Over time, that rubber can harden, smooth off, crack, or even tear away at the corners, which can make the pedal slippery and a bit ordinary to use.

As part of servicing, it’s smart to have the pads checked for glossiness, thinning, or missing sections. If the surface has gone smooth like a worn thong sole, if the ribs are mostly gone, or if there are splits, it’s time to swap them. Replacement is simple, quick, and inexpensive, and keeps the cabin compliant and comfy to drive. In some states and in NZ, excessively worn pedal rubbers can draw attention at roadworthy or WOF time, so staying ahead of it is a win.

Replacement is a straightforward push-on job:

• Pop the old pad off the metal pedal plate.
• Clean the metal face so there’s no grit or old rubber left.
• Warm the new pad slightly (sunlight or warm water) to make it pliable.
• Hook the bottom lip first, then work the edges on until it seats evenly all round.

A quality OEM‑spec pad will fit snugly and last well. Inspect at every service or at least annually, especially if the CR‑V sees a lot of city kilometres, wet boots, or sandy beaches. The accelerator doesn’t have a replaceable pad, if its surface is damaged, the pedal assembly is typically replaced as a unit.

If the pedal feels slippery, there’s visible cracking, or you can see metal peeking through, don’t wait—grab a fresh pad and restore that crisp, safe pedal feel the CR‑V is known for.

Popular questions

Does the 2008 Honda CR‑V have a replaceable brake pedal pad?
Yes. The 2008 CR‑V uses a removable rubber pad on the brake pedal. Manual models also have a replaceable clutch pedal pad, while the accelerator pedal is a hard plastic unit without a separate rubber cover.

How often should pedal pads be replaced on a 2008 CR‑V?
There’s no fixed interval—inspect them at each service or at least yearly. Replace when the surface is smooth or shiny, the ribs are worn down, or cracks and splits appear. Many last years, but heavy city driving or wet, sandy conditions can speed up wear.

Can the pedal pads be changed at home?
Definitely. With basic care it’s a DIY job: remove the old pad, clean the pedal face, and press the new pad on evenly. Avoid lubricants, as they can make the pad slip. If the pad doesn’t seat securely all the way around, it’s the wrong fit.